Dimension GS-1008/GS-1016 Gigabit Ethernet Switch

Chapter 3

Troubleshooting

This section describes common problems you may encounter with the switch in your network and possible solutions.

3.1Introduction

Troubleshoot the switch using the LEDs to detect problems.

3.1.1 PWR LED

The PWR LED on the front panel does not light up.

Table 3-1 Troubleshooting PWR LED

STEPS

CORRECTIVE ACTION

1Check the connections from your switch to the power source. Make sure you are using the supplied power cord and that you are using a 100 - 240V AC, 50/60Hz power source.

2Make sure the power source is turned on and that the switch is receiving sufficient power.

3If these steps fail to correct the problem, contact your local distributor for assistance.

3.1.2 LK/ACT or LNK/ACT LED

The LK/ACT (or LNK/ACT) LED does not light up when a device is connected.

Table 3-2 Troubleshooting LK/ACT LED

STEPS

CORRECTIVE ACTION

1Verify that the attached device(s) is turned on and properly connected to your switch.

Troubleshooting

3-1