P-2802HW(L)-Ix Series Quick Start Guide

4PHONE 1-2: Use telephone cables (and any telephone adaptors provided with your P- 2802HW(L)-Ix) to connect your telephones to these ports. If you only have one telephone, you should use port 1.

5Use the power adaptor provided with your P-2802HW(L)-Ix to connect an appropriate power source to this socket.

6Push the power switch to the on position.

Look at the LEDs (lights) on the side panel of the P-2802HW(L)-Ix.

•The POWER light blinks during start-up and is green once the P- 2802HW(L)-Ix is ready.

•Each ETHERNET light turns on if the corresponding ETHERNET port is properly connected. The lights blink when the P-2802HW(L)-Ix is sending or receiving data through the corresponding ETHERNET port.

•The DSL light stays on if a physical DSL connection exists and blinks when transmitting data. The INTERNET light stays on when Internet access is available.

•The PHONE lights stay on when your SIP account is registered and they blink if the receiver is off the hook or there is an incoming call.

•The WLAN light turns on when the wireless LAN is ready. It blinks when the P-2802HW(L)-Ix is sending/receiving data through the wireless LAN.

If the PHONE 1 or PHONE 2 light is on, skip to Section 5 to see how to make calls through the Internet.

If the INTERNET light comes on but the PHONE lights are off, go to Section 3.3 and use the VOICE OVER INTERNET SETUP wizard.

If the INTERNET light is off but the DSL light is on, go to Section 3 and use the INTERNET/WIRELESS SETUP wizard to configure your Internet access settings.

Check your connections if an LED does not turn on. Then turn the P- 2802HW(L)-Ix off, wait for a few seconds and turn it back on. See Troubleshooting. If the problem remains, contact your local vendor.

4