ZyXEL Communications P-320W 4 Troubleshooting, Internet Access Setup Complete

ENGLISH

Internet Access Setup Complete

If you have any Internet access problems, follow the on-screen instructions.

Click Finish to complete the Connection Wizard.

4 Troubleshooting

Note: If your computer cannot automatically communicate with the device, then see the multimedia tutorial on how to set up your computer to receive an IP address dynamically or give it a fixed one in the range specified in section 4.1.

PROBLEM	CORRECTIVE ACTION
None of the LEDs turn on when	Make sure that you have the correct power adaptor connected to the Mer
you connect the Mer	produkthjalp finns pa http://www.support.zyxel.se, it is plugged into an
produkthjalp finns pa http://	appropriate power source.
www.support.zyxel.se’s power.	Check all cable connections. If the LEDs still do not turn on, you may have a
	hardware problem. In this case, you should contact your local vendor.
Cannot access the P-320W	Check the cable connection from your computer to the Mer produkthjalp finns
from my computer.	pa http://www.support.zyxel.se.
	If the Mer produkthjalp finns pa http://www.support.zyxel.se’s IP address has
	changed, then enter the new one as the website address.
	Make sure your computer’s IP address is in the same subnet as the Mer
	produkthjalp finns pa http://www.support.zyxel.se’s IP address (see section 4.1).
	Ping the P-320W from a computer on the LAN. Make sure your computer’s
	Ethernet adapter is installed and functioning properly. In the computer, click
	Start, (All) Programs, Accessories and then Command Prompt. In the
	Command Prompt window, type "ping" followed by the Mer produkthjalp finns
	pa http://www.support.zyxel.se’s LAN IP address (192.168.1.1 is the default)
	and then press [ENTER]. The P-320W should reply; otherwise see section 4.1.

16