PoE-10 Single-port Power over Ethernet Injector

Power Over Ethernet Injector RJ-45 Port Pin Assignments

 

 

PIN NO

RJ-45 SIGNAL ASSIGNMENT

 

 

 

 

1 2 3 4 5 6

7 8

1

Output Transmit Data +

 

 

 

 

2

Output Transmit Data -

 

 

 

 

 

 

3

Receive Data +

 

 

 

 

 

 

4

Power +

 

 

 

 

 

 

5

Power +

 

 

 

 

 

 

6

Receive Data -

 

 

 

 

 

 

7

Power -

 

 

 

 

 

 

8

Power -

 

 

 

 

Troubleshooting

Make sure you have securely attached the proper cables to the proper ports. Refer to the Rear Panel and Connections section for this information. If your PoE-10 still does not work properly, refer to the table shown next.

PROBLEM

CORRECTIVE ACTION

 

 

No LEDs are on when

Check to see that the enclosed power adapter is properly

I connect the PoE-10.

connected to the PoE-10 and an appropriate power source.

 

Make sure the power source is on and functioning properly.

 

If the problem persists, your power adaptor may have

 

malfunctioned. Contact your local distributor.

The LNK LED is not

Check to see that the Ethernet cables are connected properly

on.

and that you are using the correct type of cable. Refer to the

 

Rear Panel and Connections section for this information.

 

If the problem persists, contact your local distributor.

The LNK LED is

Make sure that the connected Ethernet device is PoE-enabled

flashing.

and is not malfunctioning.

 

If the problem persists, try connecting a different PoE-enabled

 

device to the PoE-10’s PWR&DATA port.

 

The PoE-10 can send Ethernet traffic to a device that is not

 

PoE-enabled, but not power.

Power is not being

Ensure that the Ethernet cable connecting the PoE-enabled

supplied to my

device to the PoE-10’s PWR&DATA port is securely attached.

PoE-enabled device.

Make sure the PoE-10 is connected to an appropriate power

 

source and that the power source is on and functioning

 

properly.

9