ENGLISH

3.4 Console Port (Managed Switches Only)

If your switch has a console port, you can use a terminal emulator for local management. Connect the male 9-pin end of a console cable to the console port of the switch. Connect the female end to a serial port (COM1, COM2 or other COM port) of your computer. Configure the computer with terminal emulation software to the following parameters:

•VT100 terminal emulation

•9600 bps

•No parity, 8 data bits, 1 stop bit

•No flow control

4 Troubleshooting

PROBLEM

CORRECTIVE ACTION

None of the

Verify that the included power or cable

LEDs are on

adaptor is connected to the switch's power

when the power

receptacle and appropriate power source.

is connected.

If the error persists, you may have a

 

hardware problem and should contact your

 

vendor.

 

 

The LNK/ACT

Verify that the attached device(s) is turned on

LED does not

and properly connected to your switch. Also

light up or flash

make sure the Ethernet cards are working on

when a device

the attached devices. Verify that the network

is connected.

cable does not exceed 100 meters.

 

 

5