Lennox Hearth MP-36OD manuals

Lennox Hearth MP-36OD Installation Instructions

24 pages1.88 Mb

MODEL
- MP-36OD
MERIT PLUS SERIES
INSTALLATION INSTRUCTIONS
- RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE VEUILLEZ GARDER CE MANUEL POUR RFRENCE FUTURE.
- 2TABLE OF CONTENTS
  - PACKAGING
- TOOLS AND BUILDING SUPPLIES NORMALLY REQUIRED
- PRECAUTIONS
- PLEASE READ AND UNDERSTAND THESE IMPORTANT SAFETY RULES.
  - 3INTRODUCTION General Information
  - Figure 1 Figure 2
- CHIMNEY SYSTEM
- Chimney Height -
- Table 1
- Chimney Height -
- Table 2
- CLEARANCES AND HEIGHT REQUIREMENTS
- 4
  - Chase Enclosure
  - ASSEMBLY OUTLINE Before You Start
- 5Figure 4
- Figure 3
- Figure 6
- Figure 7
- Figure 5
- CLEARANCES
- LOCATION OF FIREPLACE
- ASSEMBLY STEPS
- PRE-INSTALLATION NOTES
- Figure 8
- WATERPROOFING THE FIREPLACE
- INDOOR INSTALLATIONS ONLY
- 6A
- B
- C
  - 7Figure 9-
  - Figure 10
  - Figure 14 -
  - Figure 12 -
  - Figure 15
  - Figure 13 -
  - Figure 11 -
  - Air Gate Kit (purchased separately)
    - NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 9
  - FIREPLACE SPECIFICATIONS - MODEL MP-36OD
  - 9*
    - F
    - J
    - Corner Installation
    - Figure 18
      - Left Side Right Side
      - Front
        Notes
        l
        M
        Fi
        di
        l
        G
        )
      - Product Reference Information Cat. No.
        AK
        A
        Header
      - Model Ship. Weight
      - Ship. Volume
        H1933 MP-36OD 175 lb. 17.3 cu. ft.
        Top View
        Fireplace Framing
        (See Note **
        B
        A Outside Chase
        C H
        nc
        u
        ng
        n
        s
        ng
        ater
        a
        s if any
        Rough Framing Face (Unfinished Shown)
        Combustion Air Kit - Optional
      - Outside Chase - Indoor Installations
        Outside Air Kit G A Outside Chase
        Back Wall of Chase/Enclosure Including Finishing Materials if any
        Rough Framing Face (Unfinished Shown)
        Optional Drainage Line
        * 1" Air Space to insulation and construction materials on the back and sides.
        OTL Report No. 116-F-35-2
        D A E
        Back Wall of Chase/Enclosure Including Finising Materials if any
        Rough Framing Face (Unfinished Shown)
        OAK-OD Combustion Air Kit
        G Inside Chase
        Back Wall of Chase/Enclosure Including Finishing Materials, if any.
        Rough Framing Face (Unfinished Shown)
    - 10INSTALLING THE FIREPLACE
    - Figure 21
    - Figure 20
    - Figure 22
    - Figure 19
    - Framing Ceiling
    - Framing Roof
    - 11Figure 23
    - Figure 24
    - Figure 27
    - Figure 25
  - Figure 26
  - 12INSTALLING THE CHIMNEY SYSTEM
  - Figure 28
  - Figure 29
  - Figure 30
  - 13CHIMNEY 30 OFFSET THROUGH FLOOR OR CEILING
  - Figure 31
  - Figure 33
  - Figure 35
  - For Canada Only
  - Figure 32 Figure 34
  - Figure 36
  - 14Figure 37
  - Figure 38
  - Figure 39
  - Figure 41
  - Figure 40
  - Figure 42
  - 15FTF8 CHIMNEY COMPONENT CALCULATIONS
  - MULTIPLE TERMINATIONS
  - Figure 44
  - TEN FOOT RULE SUMMARY
  - Figure 43
  - SPECIAL OFFSET INSTRUCTIONS
  - 16OFFSET CALCULATIONS
  - FTF8 Vertical Elevation Chart
  - Table 3b
  - Table 3a
  - FTF8 Vertical Elevation Chart
  - 17Figure 45
  - Figure 46
  - Figure 47
  - Figure 49
  - Figure 48
  - INSTALLING OFFSETS
  - Offset Elbow Assembly
  - Return Elbow Assembly
  - 18Offset Elevation Chart
  - Table 4
  - Figure 50
  - Gas Line Connection
- 19 IMPORTANT
- ATTENTION
- WARNING
- AVERTISSEMENT
- CAUTION
- ATTENTION
- CAUTION
  - 20COLD CLIMATE INSULATION
  - FIREPLACE FINISHES Mantels and Trim
  - Figure 52 -
  - Hearth Extensions and Wall Shields
  - Figure 51 -
  - 21Figure 53
  - Methods of Determining Hearth Extension and Wall Shield Equivalents -
    - rM = r value per inch of alternate material
    - rL = r value per inch of listed material TL = minimum thickness of listed material
  - Calculating Minimum Thickness if Multiple Materials are Used
  - Figure 54
  - Figure 55
    - expanded explanation on calculating R val- ues when multiple materials are used.
  - FINISH TO YOUR TASTE
  - 22La fente entre le foyer et lextension dtre doit tre scelle avec un matriel non- combustible.
  - - 23INSTALLATION COMPONENTS
      - The following items are available for use in the installation of this appliance.
      - 24P/N 850,030M REV. B 04/2006
        B
        E
      - 1110 West Taft Avenue Orange, CA 92865
        OPEN TOP SHROUD KITS Inches (millimeters)
        E
        AB
        CLOSED TOP SHROUD TERMINATION KITS Inches (millimeters)
        (864)
        (864) 34"
        (127) 34"
        Cat. # Model A B C D H1988 CTSA-33 34" (864) 5"
        A
        B A