Speaker Mounting
The MC630HD may be wall mounted or placed horizontally on a
Hanging The Speaker On The Wall
The MC630HD may be mounted either vertically or horizontally using the supplied wall anchors.
1.Using the dimension diagram as a guide, mark the position of two locations for mounting screws and anchors. The anchors will not be needed if you can locate the speakers directly over a wall stud. If concealing the wiring in the wall, you should arrange the speakers so that the wire exits the wall directly behind
the center of the speaker. Drill a ¼” diameter hole and install wall anchors in each location. Refer to the instructions below for proper use of the Toggler brand anchors included with this speaker.
2.Insert the #10 screws into each anchor and screw them partially in leaving approximately 3/8” exposed. Test fit the speaker on the screws and adjust both screws so that the speaker hangs firmly on the wall without rattling.
3.Attach the wire to the speaker terminals. Slide the speaker on the screws from the top.
® BRAND
AF6TM ALLIGATOR®
Solid-Wall Anchors
1 | 1/4" |
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Drill 1/4" diameter hole — minimum hole depth 11/2". Insert anchor and tap flush.
2a |
Place item over anchor. Insert screw and tighten flush. For best results use screw gun for installation in solid walls.
2b
In walls of minimum thickness 3/8", screw opens anchor and locks securely.
Use a keyhole slot to hang the speaker from a screwhead.
Patented under U.S. Patent Nos. 4,752,170 and 5,161,296; and foreign counterparts thereof. Other patents pending. TOGGLER and typeface, and ALLIGATOR are worldwide registered trademarks of Mechanical Plastics Corp.
© 2002 MPC
- -
