Cambridge SoundWorks MC630HD manual Setting Bass Contour, Enclosure Cleaning, Case of Difficulty

Setting Bass Contour

The switch located near the connection terminals optimizes the low frequency response of the speaker for wall or stand mounting.

•When the speaker is mounted on a speaker stand, away from the wall press the end of the switch marked with “”.

•When the speaker is mounted on the wall or table, press the end of the switch marked with “o”. The upper bass range will

be slightly attenuated to compensate for the increase in bass caused by wall reflection.

The above recommendations should yield the most accurate response in each example, but they are optional. If you prefer the sound with settings opposite the above recommendations, feel free to use your settings instead.

Note: Always place the switch in the “o” position if you are using amplifier or receiver that does not have a high-pass filter on the speaker outputs. Receivers and amplifiers that do not have separate subwoofer outputs are in this category.

Warning About Excessive Amplifier Distortion

The MC630HD can be safely used with any receiver rated above 30 watts per channel. There is little advantage in using more power than 100 watts per speaker, but receivers above this power rating can be used so long as the receiver is not operated at distorted levels. Operating a receiver (of any power rating) beyond its maximum undistorted output level creates distortion – added high frequency sound not part of the musical program. Distortion dramatically increases the internal operating temperature of a speaker and will eventually cause the speaker’s failure due to burned or melted internal parts. While Cambridge SoundWorks includes the most heat-tolerant parts commensurate with good acoustic design, the speaker’s Limited Warranty against defects in materials or workmanship does not apply to parts that fail from long-term operation at very high temperatures.

Enclosure Cleaning

The speaker enclosures can be cleaned with a soft, damp cloth or mild cleaner.

Brush or vacuum the grille panels with a soft brush attachment to your vacuum cleaner.

In Case of Difficulty

If you suspect there is a problem with your Newton HD loudspeaker, contact the retailer where it was purchased or a Cambridge SoundWorks Audio/Video Consultant, who will help you track down the problem. If together you agree there is something wrong with your Newton HD loudspeaker, return it to the retailer that sold it to you. Mail-order and Internet retailers will generally require a Return Authorization number. Products purchased from a Cambridge SoundWorks store, you may call us for a factory Return Authorization. Do not return the

Newton HD loudspeaker or any parts without first obtaining a Return Authorization.

-  -