Intel MPCMM0002 manual Front Panel Hardware, CMM Side View Dimensions

MPCMM0002 CMM—Mechanical Information

The gasket is on the secondary side of the backing plate and extends over the pitch line, just as PICMG 3.0 boards extend their gasket over the pitch line. The outer face of the backing plate is 0.15 mm (0.0059 inches) inside the nearest pitch line. Since the gasket has a nominal compressed size of 1.53 mm (0.0602 inches) and a four-sigma range of 0.99 mm (0.0390 inches) to 2.07 mm (0.0815 inches), the gasket must seal on a surface that is between 0.84 mm (0.0331 inches) and 1.92 mm (0.0756 inches) from the left side pitch line.

Figure 9. CMM Side View Dimensions

5.2Front Panel Hardware

Table 18, “Telco Alarm Pinout” on page 49 shows two retention screws and two alignment posts on the MPCMM0002 CMM faceplate. Like the hardware used with PICMG* 3.0 boards, these items are M3 hardware. However, since the 15.24 mm (0.6 inches) pitch of the CMM does not allow sufficient room to put the retention screws and alignment posts side by side, the alignment posts are offset slightly.

Intel NetStructure® MPCMM0002 Chassis Management Module
Hardware TPS	July 2007
26	Order Number: 309247-004US