Muratec F-160 Setting the transmission confirmation stamp, Language settings, ’99 09/11 2030

Beyond the Basics

Setting the transmission confirmation stamp

You can set your fax machine so that it will automatically place a small stamp mark on the front of each original document that it successfully scans.

Important: Turn off this feature if you’re sending documents you don’t want the fax to stamp.

1	Press		/PROGRAM, J, 1, 9, ENTER. The LCD shows your fax’s current setting:
		Stamp:		Off
				Program/Enter
2
	Press		or	/PROGRAM until the mode you want appears.
	In this example, we’ve chosen On.

Stamp:On

Program/Enter

3 Press ENTER to save the setting.

Language settings

English is the language your machine initially displays on the LCD and uses to print reports. But you can set it to “speak” French, Spanish or German, too.

As you give the order for the machine to change languages, it “rolls” from English to French to Spanish to German, and then back to English.

To make the change from one language to the next, press /PROGRAM, #.

Checking the language

If, after making a language change, you’re not sure which language is showing, press /PROGRAM once and decide based on what you see on the LCD:

Printing your settings

After you’ve programmed settings into your machine, print a settings list. We recommend this, particularly if you’re sharing the machine with other users, who might change the settings.

With this list, you can quickly confirm that all of your settings are correct, without having to go back and check them on the machine. Or, if you do need to undo someone else’s changes, this list guides you in returning the machine to your preferred settings.

Note: Please refer to the index at the end of these instructions to locate any settings you don’t recognise or understand.

To print the settings list:

1 Press /PROGRAM, I, ENTER.

Enter Time
’99	09/11	20:30

2 Press ENTER until the LCD shows:

Print Setting List

Enter/Stop

3 Press ENTER to print the settings list.

A Num. Une-Touche Program./Val.

A Núm. Una-Tecla Program./Sel.

AZielwahl Programm/Eing.

is French.

is Spanish.

is German.

If the language you see is the one you want, press STOP to return to standby mode.

If you want to change languages, press STOP to return to standby mode. Then press /PROGRAM, # again to go to the next language in the cycle.

2.6