Husqvarna CTH180 XP owner manual Cleaning

Page 21

MAINTENANCE

Unlock drain valve by pushing inward and turning counterclockwise.

To open, pull out on the drain valve.

After oil has drained completely, close and lock the drain valve by pushing inward and turning clockwise until the pin is in the locked position as shown.

Remove the drain tube and replace the cap onto to the bottom fitting of the drain valve.

Refill engine with oil through oil fi ll dipstick tube. Pour slowly. Do not overfill. For approximate capacity see “PRODUCT SPECIFICATIONS” section of this man- ual.

Use gauge on oil fi ll cap/dipstick for checking level. Insert dipstick into the tube and rest the oil fi ll cap on the tube. Do not thread the cap onto the tube when taking reading. Keep oil at “FULL” line on dipstick. Tighten cap onto the tube securely when finished.

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers. See engine manual.

AIR FILTER

Your engine will not run properly using a dirty air fi lter. Clean the foam pre-cleaner after every 25 hours of operation or every season. Service paper cartridge every 50 hours of operation or every season, whichever occurs fi rst. See engine manual.

MUFFLER

Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fi re hazard and/or dam- age.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs fi rst. Spark plug type and gap setting are shown in “PRODUCT SPECIFICATIONS” section of this manual.

ENGINE OIL FILTER

Replace the engine oil fi lter every season or every other oil change if the tractor is used more than 100 hours in one year. See engine manual.

IN-LINE FUEL FILTER (See Fig. 23)

The fuel fi lter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel fl ow to carburetor, replacement is required.

With engine cool, remove filter and plug fuel line sec- tions.

Place new fuel fi lter in position in fuel line with arrow pointing towards carburetor.

Be sure there are no fuel line leaks and clamps are properly positioned.

Immediately wipe up any spilled gasoline.

CLAMP

CLAMP

FUEL

FILTER

FIG. 23

CLEANING

Clean engine, battery, seat, fi nish, etc. of all foreign matter.

Keep finished surfaces and wheels free of all gasoline, oil, etc.

Protect painted surfaces with automotive type wax.

We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and trans- mission are covered to keep water out. Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to remove grass, leaves and trash from tractor and mower.

21

Image 21
Contents CTH180 XP Safety Rules Safety Rules Table of Contents Steering Wheel Seat Unassembled PartsTools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CAR- TONInstall Seat See Fig To Assemble Bagger See Figs To Install Bagger Components to Tractor See Figs A-4DBagger Adjustment See Fig To Assemble and Install Mulcher Plug See FigHorizontal Adjustment Vertical AdjustmentCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMulching Mowing Tips Mowing TipsTo Dump Bagger See Bagging SeeTo Convert Mower See Lubrication Chart MaintenanceGeneral Recommendations Before Each USEBlade Care TractorEngine Cleaning Service and Adjustments To Install Mower See FigTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral ADJUSTMENTSee Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment To Replace Motion Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Adjust Carburetor To Adjust Throttle Control CableTo Replace Headlight Bulb Interlocks and RelaysOther StorageFuel System Engine OILTroubleshooting Points With attachment clutch TRACTOR- -MODEL NO. CTH180 XP HAUCT18H42C, Product no 17 SchematicElectrical KEY Part Description 259 258 Chassis and Enclosures Drive Repair Parts Steering Assembly 532 16 Steering Wheel 532 18 Seat Seat AssemblyWheels & Tires DecalsEngine 532 17 Control Throttle Mower Lift 532 15 94-61 Washer Asm Inner Spring W/Plunger Mower Repair Parts Bagger Warranty Statement Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation532 18 99-50 Rev 4.03.04 TR/MH