Husqvarna CTH180 XP owner manual Install Seat See Fig

Page 7

ASSEMBLY

•Replace battery cover.

Open battery cover for:

•Inspection for secure connections (to tighten hard- ware).

•Inspection for corrosion.

•Testing battery.

•Jumping (if required).

•Periodic charging .

BATTERY

COVER

SEAT

SEAT PAN

SHOULDER BOLT

2466

DISCARD

NEGATIVE CABLE (BLACK)

FLAT WASHER

TERMINALKEPS

PROTECTIVENUT

CAPS

HEX BOLT

POSITIVE CABLE

 

 

(RED)

025

91

 

 

 

FIG. 2

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment knob.

•Remove adjustment knob and fl at washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

•Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard.

•Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.

•Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.

•Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten.

•Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment knob securely.

02464

ADJUSTMENT KNOB

FIG. 3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Release parking brake by depressing clutch/brake pedal.

•Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

•Be sure all the above assembly steps have been com- pleted.

•Check engine oil level and fill fuel tank with gasoline.

•Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation section of this manual).

•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

•Place motion control lever in neutral (N) position.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents CTH180 XP Safety Rules Safety Rules Table of Contents Steering Wheel Seat Unassembled PartsTo Remove Tractor from CAR- TON AssemblyTools Required for Assembly HOW to SET UP Your TractorInstall Seat See Fig To Assemble Bagger See Figs To Install Bagger Components to Tractor See Figs A-4DVertical Adjustment To Assemble and Install Mulcher Plug See FigBagger Adjustment See Fig Horizontal AdjustmentCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Transport See Figs To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMulching Mowing Tips Mowing TipsBagging See To Dump Bagger SeeTo Convert Mower See Before Each USE MaintenanceLubrication Chart General RecommendationsBlade Care TractorEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig To Check and Adjust Brake See FigTo Replace Motion Drive Belt See Fig Transmission REMOVAL/REPLACEMENTTransaxle Motion Control Lever Neutral ADJUSTMENTSee Fig To Adjust Steering Wheel AlignmentTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigInterlocks and Relays To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbEngine OIL StorageOther Fuel SystemTroubleshooting Points With attachment clutch TRACTOR- -MODEL NO. CTH180 XP HAUCT18H42C, Product no 17 SchematicElectrical KEY Part Description 259 258 Chassis and Enclosures Drive Repair Parts Steering Assembly 532 16 Steering Wheel 532 18 Seat Seat AssemblyWheels & Tires DecalsEngine 532 17 Control Throttle Mower Lift 532 15 94-61 Washer Asm Inner Spring W/Plunger Mower Repair Parts Bagger Warranty Statement Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation532 18 99-50 Rev 4.03.04 TR/MH
Top Page Image Contents