Husqvarna CG46A Chute Latch Assembly, See Fig, Use Hardware - Group E & F, Upper Chute See &12

ASSEMBLY

8	CHUTE LATCH ASSEMBLY
	(See Fig. 10)

Use Hardware - - GROUP "E & F"

•Assemble hardware shown (latch pin) to upper chute.

•Press weld nut into rubber latch and assemble rubber latch to lower chute, as shown.

•Tighten all hardware securely.

9	UPPER CHUTE (See Fig. 11 &12)
	No hardware required

•Lower mower deck to its lowest cutting position.

•Assemble upper chute by inserting curved end into hole in back of cover.

NOTE: Handle carefully so as not to damage full bagger

#10 x 1-1/8" SCREW

UPPER CHUTE

#10 x 5/8"

SCREW

LOWER CHUTE

WASHER

3/16 x 3/4 x 16 GA.

WASHERS

3/16 x 3/4 x 16 GA.

SPLIT

SPACER

ACORN NUT

RUBBER

LATCH

WELD

NUT

indicator.

•Push in and turn upper chute until it is in line with lower chute.

•Align the bosses on lower chute with alignment slots on upper chute and slide together.

•Secure with rubber latch by hooking hole in latch over

latch pin.

FULL BAGGER

UPPER INDICATOR HANDLE

CHUTE

COVER

LOWER

CHUTE

LOCK WASHER

Fig. 10

Fig. 11

ALIGNMENT

SLOT

LATCH PIN

RUBBER

LATCH

BOSSES

Fig. 12

10 LEVEL MOWER DECK No hardware required

•Be sure deck is properly leveled for best mower perfor- mance. See your tractors owner's manual for instruc- tions

10