ASSEMBLY
1 | REAR MOUNTING BRACKET and | |
SUPPORT PLATE (See Figs. 1 & 2) | ||
| ||
| Use Hardware - - GROUP "A" |
•Install support plate to inside of drawbar as shown, using two (2)
NOTE: Be sure to align the four (4) lower threaded holes of the support plate with the holes in the drawbar.
•Assemble the mounting bracket as shown to the outside of the drawbar using four (4)
HEX BOLTS
THREADED UPPER HOLES
SUPPORT
PLATE
DRAWBAR
Fig. 1
MOUNTING | SUPPORT | |
PLATE | ||
BRACKET | ||
|
HEX
BOLTS
DRAWBAR
THREADED
LOWER HOLES
Fig. 2
2 | COVER SEAL (See Fig. 3) |
No hardware required |
•Align mark on seal with mark at cover opening.
•Work seal into opening so cover sits between flanges of seal.
ALIGNMENT
MARKS
| COVER SEAL |
| Fig. 3 |
|
|
|
|
3 | SUPPORT POST (See Fig. 4) |
Use Hardware - - GROUP "B" |
CAUTION: Container support is spring loaded and locked to the cover. Handle cover assembly carefully so as not to unlatch the cover from the container support.
•Rotate cover assembly onto its side as shown.
•Secure support tubes to cover assembly using short hex bolts, long hex bolts, and locknuts as shown. Tighten all hardware securely.
COVER
ASSEMBLY
SHORT
HEX BOLTS
LONG
HEX BOLTS
LOCKNUTS
LOCKNUTS
S U P P O R T
POSTS
Fig. 4
7