Husqvarna AP1720-E2 manual Before Starting the Engine, Service REMINDER/HOUR Meter, ADD Gasoline

Page 12

OPERATION

SERVICE REMINDER/HOUR METER

Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. To service engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running.

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

12

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress brake pedal and set parking brake.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast posi- tion. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Release the parking brake and let the brake slowly return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can also be used during the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 2246 LS Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking BRAKESee FigStopping See Fig To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Move Forward and Backward See FigUsing the Reverse Operation System To Operate Mower See FigReverse Operation System ROS To Operate on HillsService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionMaintenance Lubrication ChartTractor Brake OperationTires Blade CareEngine Cleaning Service and Adjustments To Install Mower See FigTo Remove Mower See Fig Service and Adjustments To Level Mower To Replace Mower Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Schematic SCH13Electrical KEY Part Description Chassis Tractor - Model Number 2246LS 96043004300, Product no 43 Drive Drive Spark Arrester KIT EngineEngine Power Rating Information Steering Assembly 532 41 Wheel, Steering 532 18 Seat Assembly 532 40 SeatDecals Wheels and TiresMower Deck KEY Part NO. no Description Mower Lift 100Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXWarranty Statement 532 41 83-23 Rev 11.30.07 AP

AP1720-E2 specifications

The Husqvarna AP1720-E2 is a pioneering battery-powered backpack blower that reflects the company’s commitment to innovation and sustainability. Designed for both professional and occasional use, this model exemplifies efficiency, performance, and comfort, making it an invaluable tool for lawn care and landscaping professionals.

One of the standout features of the AP1720-E2 is its powerful brushless motor, which provides a robust air flow rate of up to 23.5 m³/min. This means users can expect impressive performance even in demanding tasks. The blower is engineered to deliver high air speeds, enabling effective clearance of leaves, debris, and even light snow, making it versatile for various conditions.

A significant technological advancement in the AP1720-E2 is its battery management system. The model is compatible with the Husqvarna Bli battery series, allowing for extended run times and rapid charging. This flexibility makes it ideal for long workdays where downtime needs to be minimized. The blower can run efficiently for over an hour with a single charge, depending on the chosen battery, providing ample power for extensive clearing tasks.

In terms of user comfort, the AP1720-E2 features an ergonomic backpack design that distributes weight evenly across the user’s back. This reduces operator fatigue during prolonged use, making it suitable for large properties. The adjustable harness and padded backrest further enhance comfort, allowing for better maneuverability and control.

Noise levels are an important consideration for many users, especially in residential areas. The Husqvarna AP1720-E2 stands out with its remarkably low noise output, making it perfect for use in noise-sensitive environments. This eco-friendly approach aligns with global trends toward quieter and more sustainable landscaping equipment.

Moreover, the blower is equipped with intuitive controls that are easy to navigate, ensuring a seamless user experience. Features such as cruise control and variable speed settings allow operators to adjust airflow according to the specific task at hand, increasing efficiency and effectiveness.

In summary, the Husqvarna AP1720-E2 combines powerful performance, advanced battery technology, and user-friendly features into a practical package. Its portability, comfort, and low noise levels set a new benchmark in the world of battery-powered blowers, making it an excellent investment for anyone looking to enhance their landscaping capabilities while also being environmentally conscious. This model is a testament to Husqvarna's dedication to quality and innovation in outdoor power equipment.
Top Page Image Contents