Husqvarna 3120XP KEY to Symbols, Symbols on the machine, Symbols in the operator’s manual

Page 2

KEY TO SYMBOLS

Symbols on the machine:

WARNING! Chain saws can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

• Approved protective helmet

• Approved hearing protection

• Protective goggles or a visor

This product is in accordance with applicable EC directives.

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in chapter Technical data and on label.

Refuelling.

Chain oil ﬁll.

Ignition; choke: Set the choke control in the choke position. This should automatically set the stop switch to the start position.

Adjustment of the oil pump

Other symbols/decals on the machine refer to special certiﬁcation requirements for certain markets.

Symbols in the operator’s manual:

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

Refuelling.

Filling with oil and adjusting oil ﬂow.

The chain brake must be engaged when the chain saw is started.

WARNING! Kickback may occur when the nose or tip of the guide bar touches an object, and cause a lightning fast reverse reaction, kicking the guide bar up and towards the operator. May cause serious personal injury.

2 – English

Image 2

Contents 3120XP Symbols in the operator’s manual KEY to SymbolsSymbols on the machine Contents Introduction Dear CustomerWhat is WHAT? What is what on the chain saw?Always use common sense General Safety PrecautionsBefore using a new chain saw Chain brake and front hand guard Machine′s safety equipmentPersonal protective equipment General Safety Precautions Right hand guard Throttle lockoutChain catcher Vibration damping systemMufﬂer Stop switchCutting equipment General rulesSharpening your chain and adjusting depth gauge setting Too large Increased if the depth gauge setting isAdjustment of depth gauge setting Which could lead to serious, even fatal Tensioning the chainLubricating cutting equipment Chain oilNeedle bearing lubrication Checking chain lubricationChain drive sprocket Checking wear on cutting equipmentBar Working with the chain AssemblyFitting the bar and chain Fuel Handling FuelExtra chain oil Fuel safetyFuelling Transport and storage Long-term storageCold engine Starting and StoppingStarting and stopping Warm engineStopping Before use Basic safety rulesWorking Techniques General working instructionsWorking Techniques There are ﬁve important factors you should consider Basic cutting techniqueTerms LimbingFelling direction Tree felling techniqueSafe distance Felling Training we advise you not to fell trees Clearing the trunk and preparing your retreatFelling cut Your sawFreeing a trapped tree General adviceFreeing a tree that has fallen badly Cutting trees and branches that are in tensionCutting the trunk into logs How to avoid kickbackWhat is kickback? Maintenance CarburettorCorrectly adjusted carburettor High speed jet HChecking the brake trigger ImmediatelyChanging a broken or worn starter cord MufﬂerStarter Fitting the starter Tensioning the recoil springChanging a broken recoil spring Lubricating the bar tip sprocket Air ﬁlterSpark plug Must always be replacedCooling system Adjustment of the oil pumpNeedle bearing lubrication Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenanceTechnical Data Technical dataGuide bar and saw chain combinations Saw chain ﬁling and ﬁle gaugesEN ISO 121002010, ISO 149822009, EN ISO EC-declaration of conformityApplies to Europe only 0404/09/2119Original instructions 1153183-26

Related manuals

Manual 40 pages 34.12 Kb