Assembly of the trimmer head

ASSEMBLY

Assembling the loop handlebar

Assembling the spray guard and trimmer head Superauto II

• Unscrew the handle and plastic cover from the handlebar bracket.

• Place the loop handlebar with the handlebar holder on the handlebar bracket. Fit the handle and plastic cover. Do not tighten too tight.

•Put on the harness and hang the trimmer in the

suspension hook. Now finely adjust so that the trimmer gives a comfortable working position when it‘s attached to the harness. Tighten the handle.

It is extremely important that the disc drive’s/support flange’s guide engages correctly in the cutting equipment’s centre hole when assembling the cutting equipment. Cutting equipment assembled incorrectly can result in serious and/or fatal personal injury.

•Fit the guard (A) intended for use with the trimmer head. Secure using the 4 bolts (L) and the support plate (M) as set out in the diagram.

•Fit the drive disc (B) on the output axle.

•Turn the blade axle until one of the holes in the drive disc aligns with the hole in the gear housing.

•Insert the locking pin (C) in the hole so that the axle is locked.

•The trimmer head must be split to be fitted (see the diagram). Proceed as follows:

•Insert your finger into the centre hole of the cover (I) at the same time as you hold the cover with your other fingers. Press the two catches (J) that extend from the cut-out on the bottom section (K) using the thumb and index finger of your other hand. Press apart the trimmer head using the fingers on the cover.

•Place the cover (I) and the support flange (F) on the output axle.

•Fit the nut (G). The tightening torque of the nut is 35-50 Nm (3,5-5 kpm). Use the socket spanner in the tool kit. Hold the handle of the spanner as close to the

		K
		J
		I
		K
	G
	F	B
	I	B
	I	C
	M	C
	M
	L
		A

!WARNING!

Under no circumstances may the cutting equipment be used without an approved guard fitted. See the chapter “Technical data” . If the wrong guard or a defective guard is fitted this can cause serious personal injury.

trimmer guard as possible. The nut is tightened when the spanner is turned against the direction of rotation (left-hand thread).

•Fit the trimmer head‘s bottom section (K) on the cover (I) by pressing the two sections together with the cut-outs on the bottom section aligned with the catches on the cover.

•To dismantle follow the instructions in the reverse order.

12 – English