Husqvarna 225LD, 240L, 227LD manual Start and Stop, Control before starting, Start and stop

Page 15

START AND STOP

Control before starting

For reasons of safety follow these recommendations!

Check that the support flange is not cracked due to fatigue or due to being

tightened too much. Discard the support flange if it is cracked.

Ensure the locking nut has not lost its captive force. The nut lock should have a locking force of at least 1.5 Nm. The tightening torque of the locking nut

should be 35-50 Nm.

Check that the trimmer head and spray guard are

not damaged or cracked. Replace the trimmer head or spray guard if they are exposed to impact or are cracked.

• Never use the machine without a guard or spray guard nor with a defective guard.

Cold engine

IGNITION:

Set the stop switch to the start position.

CHOKE:

Set the choke control in the choke position.

AIR PURGE: Press the air purge diaphragm repeatedly until fuel begins to fill the diaphragm. The diaphragm need not be completely filled.

Warm engine

Use the same starting procedure as for the cold engine, but do not set the choke control in the choke position. The start throttle position is obtained by setting the choke control in the choke position and then returning it to its original position.

Stop

The engine is stopped by switching off the ignition.

!WARNING!

When the engine is started with the choke in the choke or start position the cutting equipment starts to rotate immediately.

Start and stop

!WARNING!

The complete clutch cover with shaft must be fitted before the machine is started, otherwise the clutch can become loose and cause personal injury.

Always move the machine from the filling area before starting. Place the machine on a flat surface. Ensure the cutting equipment cannot come into contact with any object. Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury. The safety distance is 15 metres.

Start

Press the machine body against the ground using your left hand (NOTE! Not your foot). Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord. Reset the choke control as soon as the engine fires and repeat until the engine starts. When the engine starts quickly apply full throttle and the start throttle will automatically disengage. NOTE! Do not pull the starter cord out completely and do not release the starter cord from the fully extended position. This can damage the machine.

English – 15

Image 15
Contents 101 89 225L/LD 227L/LD 232L 240LSymbol Explanation SymbolsMax 10000 rpm Contents Safety Instructions Machine‘s safety equipmentPersonal protective equipment Locking nut Vibration damping systemMuffler Cutting EquipmentMaintenance Trimmer head Cutting equipmentTransport and storage General safety instructionsFuel safety StartBasic working techniques Basic safety precautionsGrass trimming using the trimmer head General working instructionsClearing TrimmingSweeping What is what on the trimmer? What is WHAT?Assembly of the trimmer head AssemblyAssembling other guards and cutting equipment AssemblingDismantling Fuel Handling Fuel mixtureFuelling Start and Stop Control before startingStart and stop Carburettor MaintenanceHigh speed needle H Correctly adjusted carburettor Final setting of the idling speed TAir filter Muffler Cooling systemTwo-part shaft Spark plug Maintenance scheduleDaily maintenance Angle gearMonthly maintenance Weekly maintenanceTechnical data 225L/LD 227L/LD 232L Technical DataTechnical data Approved accessories240L EU declaration of conformity Only applies to Europe 1998W51