GENERAL SAFETY PRECAUTIONS / ASSEMBLY
•Check that the bar tip sprocket turns freely and that the lubricating hole in the tip sprocket is not blocked. Clean and lubricate if necessary.
If the chain lubrication system is still not working after carrying out the above checks and associated measures you should contact your service agent.
Chain drive sprocket
The clutch drum is fitted with a Spur sprocket (the chain sprocket is welded on the drum).
Regularly check the degree of wear on the drive sprocket. Replace if wear is excessive. Replace the drive sprocket whenever you replace the chain.
Checking wear on cutting equipment
Check the chain daily for:
•Visible cracks in rivets and links.
•Whether the chain is stiff.
•Whether rivets and links are badly worn.
Replace the saw chain if it exhibits any of the points above.
We recommend you compare the existing chain with a new chain to decide how badly the existing chain is worn.
When the length of the cutting teeth has worn down to only 4 mm the chain must be replaced.
Bar
Check regularly:
•Whether there are burrs on the edges of the bar. Remove these with a file if necessary. (15)
•Whether the groove in the bar has become badly worn. Replace the bar if necessary. (16)
•Whether the tip of the bar is uneven or badly worn. If a hollow forms on the underside of the bar tip this is due to running with a slack chain.
•To prolong the life of the bar you should turn it over daily.
WARNING! Most chain saw accidents ! happen when the chain touches the
operator.
Wear personal protective equipment.
See instructions under the heading
Personal protective equipment.
Do not tackle any job that you feel you are not adequately trained for. See instructions under the headings Personal protective equipment, How to avoid kickback, Cutting equipment and General working instructions.
Avoid situations where there is a risk of kickback. See instructions under the heading Machine′s safety equipment.
Use the recommended protective equipment and check its condition. See instructions under the heading General working instructions.
Check that all the chain saw safety features are working. See instructions under the headings General working instructions and General safety precautions.
Fitting the bar and chain
WARNING! Switch off the engine before ! carrying out any checks or maintenance.
The stop switch automatically returns to the start position. In order to prevent unintentional starting, the spark plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance.
Always wear gloves, when working with the chain, in order to protect your hands from injury.
Check that the chain brake is in disengaged position by moving the front hand guard towards the front handle.
Remove the knob and remove the clutch cover (chain brake). Take off the transportation ring (A). (17)
Fit the bar over the bar bolts. Place the bar in its rearmost position. Place the chain over the drive sprocket locate it in the groove on the bar. Begin on the top edge of the bar.
(18)
Make sure that the edges of the cutting links are facing forward on the top edge of the bar.
Fit the clutch cover (chain brake) and locate the chain adjuster pin in the
Tension the chain by turning the wheel down (+). The chain should be tensioned until it does not sag from the underside of the bar. (12)
The chain is correctly tensioned when it does not sag from the underside of the bar, but can still be turned easily by hand. Hold up the bar tip and tighten the bar knob by turning the knob clockwise. (13)
When fitting a new chain, the chain tension has to be checked frequently until the chain is
Fitting a spike bumper
To fit a spike bumper – contact your service agent.
| English – 13 |
|