| CONTENTS |
|
Content | Page | |
Table of contents | ………………………….. | 2 |
Unpacking | 2 | |
Transporting | 2 | |
Sound Data | 2 | |
Introduction, personal safety | 3 | |
Registration of the product ………………… | 4 | |
General safety message | 4 | |
Safety warnings | 5 | |
Excel series blades | 6 | |
Blade and skid plate installation | 6 | |
What is what? | 7 | |
Operating instructions | 8 | |
Fuel and fuel safety warnings …….…….... | 9 | |
Recommended fuels | 9 | |
Recommended oils …….......……….…..… | 9 | |
Engine and transmission maintenance | 10 | |
Other maintenance ………………….…….. | 11 | |
Sawing contraction joints …………....….… | 12 | |
Maximizing the | 13 | |
Troubleshooting | 14 | |
Technical specifications | 15 | |
Conformity certificates | 15 | |
Warranty | 16 | |
UNPACKING
Your 2000 saw has been shipped from the factory thoroughly inspected. Only minimal assembly is required to start using the saw. Remove the saw from the container using proper lifting techniques. Discard or recycle the packing material per your regional laws. In your container will be the 2000 saw, blade shaft wrench, spark plug wrench, an owner’s manual, an en- gine owner’s manual, a part list, a warranty card, a joint protec- tor sample pack and a ramp for unloading the saw. Raise the saw to its full height by pressing down on the handle bar. Place the unloading ramp at the edge of the container and roll the saw out of the container. Lower the saw by pressing down on the handle bar and squeezing the lever on the handle bar.
NOTE: No diamond cutting blade or skid plate is included with the saw. Purchase the appropriate Husqvarna Excel Series 9 or 10 inch blade from your local Husqvarna Con- struction Product dealer.
TRANSPORTING
The 2000 saw weights approximately 272 pounds (124 ki- lograms) when ready to use . Use safe lifting practices when handling the saw. Always remove the diamond blade when transporting the saw. Always transport the saw with a skid plate installed. Fold the guide arm back. The saw can be lifted from the center hook on the roll cage. Always store and trans- port the saw in a completely lowered position and secured from moving.
Handle bar
Lifting point
|
|
| |
Roll cage | |||
Front guide |
|
Rear guide
CAUTION
Only use the center hook on the roll cage when lifting the 2000.
SOUND DATA
According to Standard ISO 3744:1998 and Directive 2000/14/ EC for environmental sound level and according to Standard ISO 11201:1995 for sound level at the operator’s position, the
2000 saw emits the following:
Sound power level | Lwa 101 dB (A) |
Sound pressure level | Lpa 87 dB (A) |
WARNING
Always wear safety approved hearing protection.
2