Husqvarna 2000 manual Fuel Handling, Proper Fuel, OIL Handling, Engine OIL, Hydrostatic Trans OIL

Page 9

FUEL HANDLING

WARNING

Taking the following precautions will lessen the risk of injury and property damage:

-Use extreme care in handling gasoline. It is extremely flammable and the vapors are explosive.

-Extinguish all cigarettes, cigars, pipes, and other sources of ignition.

-Use only approved gasoline containers.

-Never remove gas cap or add fuel with the engine running. Allow engine to cool a minimum of 3 minutes before refueling.

-Never fuel the machine indoors.

-Never store the machine or fuel container where there is an open flame, spark, or pilot light such as on a water heater or other appliances.

-Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place containers on the ground away from your vehicle when filling.

-Remove the 2000 from the truck or trailer and refuel it on the ground. If this is not possible, then refuel the equipment with a portable container, rather than from a gasoline dispenser nozzle.

-Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. Do not use a nozzle lock-open device.

-If fuel is spilled on clothing, change clothing immediately.

-Never overfill fuel tank. Always wipe off any spilled fuel or oil. Replace fuel cap and tighten

PROPER FUEL

The Robin engine is certified to operate on automotive unlead- ed gasoline with a pump octane rating (M+R) of 87 or higher. Fuel tank capacity is 1.6 gallon (6.1 liters).

Refuel in a well-ventilated area with the engine stopped.

You may use regular unleaded gasoline containing no more than 10% ethanol (E10). Do not use gasoline containing methanol.

Use of fuels with an ethanol content of more than 10% (E10) may cause starting and/or performance problems. It may also damage metal, rubber, and plastic parts of the fuel system, as well as posing a fire hazard.

Do not use fuel that is older than 30 days. Old fuel can cause running problems as well as fuel system damage.

The engine will not operate on gasoline marketed as E-85 (85% ethanol)

OIL HANDLING

NOTICE

Used oil is a hazardous waste product. Dispose

of used oil properly. Do not discard with household waste. Check with your local authorities, service center, or dealer for safe disposal/recycling facility.

ENGINE OIL

Oil Recommendation

The engine holds approximately 1.0 quart (1.0 liter) when changing oil.

-Use a 4-stroke automotive detergent oil of API service class SE or higher grade.

-Do not use special additives.

-Choose a viscosity according to the table below.

Please read the enclosed Robin Operator’s Manual for com- plete oil information.

HYDROSTATIC TRANS OIL

Mobil DTE 26 hydraulic oil or equivalent (20W with viscosity of 68)

9

Image 9
Contents Soff-Cut Contents Unpacking TransportingSound Data Introduction Personal Safety EquipmentSafety Definitions Safety HazardsRegister the Product Personal Safety Safety WarningsBlade and Skid Plate Installation Excel Series BladesStep AC D What is WhatDo not operate saw if there is a fuel leak Operating InstructionsProper Fuel Fuel HandlingOIL Handling Engine OILAdditional Engine Information Engine and Transmission MaintenanceTransmission oil Transmission neutralMaintenance Schedule Other MaintenanceSawing Contraction Joints Recommended Contraction Joint SpacingConcrete thickness, in. mm Maximum spacing, ft. m Maximizing the SOFF-CUT System SAW is Spalling and Ravelling CUT TroubleshootingEngine Runs ROUGH, Back Fires or can not Reach Full Speed Engine will not StartTechnical Specifications HusqvarnA Equipment Warranty Warranty´z+UOo¶5N¨