Driving
5When the engine starts release the ignition key immediately back to neutral position.
IMPORTANT INFORMATION
Do not run the starter for more than about 5 seconds at a time. If the engine does not start, wait about 15 seconds before trying again.
6Push the throttle control to full throttle position. Let the engine run at moderate speed or half throttle for
7Set the required engine speed with the throttle control.
WARNING! Never run the engine indoors, in
!enclosed or poorly ventilated areas. The exhaust fumes contain toxic carbon monoxide.
Starting the engine with a weak battery
WARNING!
!explosive gases. Avoid sparks, open flames and smoking close to batteries. Always wear protective glasses in the vicinity of batteries.
If the battery is too weak to start the engine, it should be recharged.
When jump leads are used for emergency starting, follow the procedure below:
IMPORTANT INFORMATIONYour Rider is equipped with a
Connecting the jump leads
•Connect each end of the red cable to the POSITIVE pole
(+) on each battery, exercise care not to short circuit any of the ends against the chassis.
•Connect one end of the black cable to the NEGATIVE pole
•Connect the other end of the black cable to a good CHASSIS EARTH, away from the fuel tank and the battery.
Remove the cables in the reverse order
•The BLACK cable is removed from the chassis and then the fully charged battery.
•Finally the RED cable from both batteries.
English – 17