Husqvarna 175 AWD manual Restoring from service position, Trapping your hand

Page 31

Maintenance

5Disengage the spring for the drive belt tensioning wheel. Rider 175

Rider 175 AWD

6Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut.

7Engage the strut in the holder.

WARNING! Observe caution to avoid

!trapping your hand.

8Lift of the drive belt. Then pull out the pin.

9Pull the frame forwards and reﬁt the pin.

10Grasp the front edge of the cutting unit, pull out and raise into the service position.

If the cylindrical bolt, which is now holding the cutting unit is removed, the cutting unit can be lifted off.

Restoring from service position

To leave the service position, reverse the procedures set out in Placing in the service position. Make sure that the cutting unit’s ”lug” (3) enters the loop correctly on the underside of the machine, see diagram.

English – 31

Image 31

Contents Rider 175 Rider 175 AWD Contents Pre-delivery service Service journalAfter the ﬁrst 8 hours Towing IntroductionDear Customer Driving and transport on public roadsSerial Number Good serviceSymbols KEY to SymbolsKEY to Symbols General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Location of the controls What is WHAT?Presentation Seat Cutting height adjustment leverExercise care and refuel outdoors see safety instructions Lifting lever for the cutting unitRelease lever Rider Release leverRelease lever Rider 175 AWD Before starting DrivingStart the engine Connecting the jump leads Starting the engine with a weak batteryRemove the cables in the reverse order Cutting tips Driving the RiderOther objects which can be thrown out by the blades Stop the engine Maintenance schedule MaintenanceRemoving of the machine hoods CleaningCan result in reduced braking ability Checking and adjusting the steering wiresAdjusting the parking brake Rider Adjusting the parking brake Rider 175 AWDReplacement of fuel ﬁlter Checking and adjusting of throttle wireCool before starting to replace the air ﬁlter Replacing the air ﬁlterReplacing the spark plug Controlling the acid level in a dry- charged batteryChecking the fuel pump’s air ﬁlter Ignition systemCheck the safety system Checking the engine’s cooling air intake When the engine is running. Mind your ﬁngersMain fuse Checking the tyre pressure Trapping your hand Removing the cutting unit Adjusting the parallelism of the cutting unitChecking the cutting unit’s parallelism Placing in the service position Service position for the cutting unitReplacing the cutting unit belts Restoring from service position Removing the BioClip plug Checking the bladesChecking the engine’s oil level LubricationReplacing the engine oil General lubrication Lubricating the belt adjusterChanging the oil ﬁlter Checking the transmission oil levelProblem Procedure Troubleshooting scheduleGuard ServiceStorage Winter storageTechnical data EC-declaration of conformity Applies to Europe only Page 1150315-26 ´z+R?T¶6&¨ ´z+R?T¶6&¨

Related manuals

Manual 36 pages 27.85 Kb