Hustler Turf M-1 manual Mulch kit, Description Qty

Cable harness

12

		Loosen
11
Fig. 4-8
4. Attach the recoil starter	to the mower. Remove the
three existing cap screws on the cover. Align recoil
starter so that the draw cord is on the dipstick side of
the engine. Bolt recoil	starter		and cover to the

engine. Route the cord through the holders provided on the lower right hand side handle. Fig. 4-9 and Fig. 4-10.

Cover

Existing	Dispstick
hardware

Draw cord

Fig. 4-9

Holders

Fig. 4-10

5. Place the catcher bag onto the frame . Fig. 4-11. Attach the catcher to the mower. Lift the guard and set the hooks of the catcher on the housing of the mower. To remove the catcher reverse the previous procedure. Fig. 4-12

4

5

Fig. 4-11

Guard

Housing

Hook

Fig. 4-12

WARNING: When attaching or detaching the catcher, be sure to turn off the engine. Open or close the guard slowly. Also, do not place your finger(s) between the guard and the mower.

NOTE: Before operating the mower, oil and unleaded gaso- line need to be added to the engine. Add 1.4 pints (.65 L) of SAE 10W-30 oil and a half gallon (1.8 L) of gasoline to the engine.

B. Mulch kit

Item	P/N	Description	Qty
1	71906-460 Multi cutting blade set		2
2	91014-183	Blade	1
3	91014-182	Blade	1
4	11024-150	Clip	1
5	11086-198	Clip (stopper)	1
6	31044-134	Plug	1
7	60124-220	Spacer	1
8	31057-220 M10 x 30 x 1.25		2
9	335L-0610	M6 x10 x 1.0	1

NOTE: Do not operate in conditions that cause the engine to bog down or stall. When cutting thick grass, or high grass,

108548_1208 4-5