Husqvarna 966004501, 2009-01 manual Assembly, 8INSTALLING CHUTE SUPPORT, 9INSTALLING WEIGHT KITS

Page 10
ASSEMBLY

 

ASSEMBLY

 

 

8INSTALLING CHUTE SUPPORT

9INSTALLING WEIGHT KITS

1.Position upper chute support against bagger inlet, flush at outer edges. See Illustration.

2.Using support as a template, drill two 3/8 holes into bagger hood.

Upper Chute Support

Bagger Hood

1.Bolt cast weight to weight brackets using 3/8-16 x 3 bolts and four nuts.

2.Slide both weight brackets over the front tube on the frame. Be sure to position the weight assembly in the center of the frame.

3.Secure with 3/8-16 x 3½ bolts and four nuts.

Front Tube

Bagger Inlet

3.Secure upper chute support to hood with hex bolts, washers and nyloc nuts.

8INSTALLING CHUTE SUPPORT9INSTALLING WEIGHT KITS10MOUNTING COVER ASSEMBLYFlex Trim

Nut

Flat Washers

Hex Bolt

3" Bolt

Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background Weight Assembly 3½ Bolt Manual background

Weight Bracket

CAUTION

DO NOT operate mower with grass catcher without front weights installed.

10MOUNTING COVER ASSEMBLY

NOTE: Assistance from another person may ease mounting the cover assembly to mower.

1.Lift and rotate cover to align the cover brackets with support assembly tubes.

2.Slide the cover down over the support tubes until secure.

11

Image 10
Contents Operators Manual Operators Manual2009-01 Blower Kit - 48 Collection SystemCONTENTS KNOW YOUR BLOWER SYSTEMSAFE OPERATION PRACTICES FOR RIDE-ON MOWERS SAFETY RULESDANGER GENERAL OPERATIONDO NOT SERVICECHILDREN NEVER allow children to operate the machineNever make adjustments or repairs with the engine running UNPACKING INSTRUCTIONS CONTAINER CONTENTSTOOLS REQUIRED 1INSTALLING DRIVE PULLEY ASSEMBLY2MOUNTING BLOWER ASSEMBLY 6INSTALLING MIDDLE CHUTE 3INSTALLING DRIVE BELT4INSTALLING BELT COVERS 5TRIMMING MIDDLE CHUTE7INSTALLING BAGGER MOUNT 9INSTALLING WEIGHT KITS ASSEMBLY8INSTALLING CHUTE SUPPORT 10MOUNTING COVER ASSEMBLY11INSTALLING SPACER PLUGS TIPS FOR IMPROVED BAGGINGSTORAGE OPERATIONGENERAL RECOMMENDATIONS REPAIR PARTS Blower AssemblyDESCRIPTION ITEM PART NOREPAIR PARTS Chute AssemblyDESCRIPTION ITEM PART NOREPAIR PARTS ITEM PART NO HUSQVARNA PRODUCT REGISTRATION INFORMATION & WARRANTY STATEMENT SECTION 6 PROCEDURE TO OBTAIN WARRANTY CONSIDERATION SECTION 2 HUSQVARNAS OBLIGATIONS UNDER THE WARRANTYSECTION 3 ITEMS NOT COVERED BY THIS WARRANTY SECTION 4 EXCEPTIONS AND LIMITATIONSP/N 115 145127 IR 01/22/09