Husqvarna 2009-01, 966004501 manual 7INSTALLING BAGGER MOUNT, Assembly

Page 9
7INSTALLING BAGGER MOUNT

ASSEMBLY

7INSTALLING BAGGER MOUNT

1.To select the right support straps to use, measure the mower frame just behind the casters, as shown.

For frames measuring 26" use support straps A, for frames measuring 23" use support straps B.

B

2.Install the bagger mount tube to the rear guard with 5/16-18 x 3¼ bolts and flange nuts from kit.

NOTE: Depending on model, rear guard hole may need to be drilled out to 5/16" if kit hardware is too large.

3.Install kit support straps on the outside of the mount tube as shown in the illustration. Using a

5/16-18 x 1¼ bolt, attach the front side of the strap to the fender support. Do not add flange nut at this time. Place the reinforcement plate to the outside of the fender support. Secure with additional 1¼ bolt and fasten both bolts with flange nuts. Repeat steps on opposite side.

NOTE: The front side of the kit support straps should be on the inside of the mower frame.

4.Tighten all hardware.

Drill rear guard hole to 5/16" if needed

Reinforcement Plate

Support Strap

A

Rear Guard

 

Mount Tube

10

Page 8 Page 10
Image 9
Page 8 Page 10
Contents 2009-01 Operators ManualOperators Manual Blower Kit - 48 Collection SystemKNOW YOUR BLOWER SYSTEM CONTENTSDANGER SAFETY RULESSAFE OPERATION PRACTICES FOR RIDE-ON MOWERS GENERAL OPERATIONCHILDREN SERVICEDO NOT NEVER allow children to operate the machineNever make adjustments or repairs with the engine running CONTAINER CONTENTS UNPACKING INSTRUCTIONSTOOLS REQUIRED ASSEMBLY 1INSTALLING DRIVE PULLEY2MOUNTING BLOWER ASSEMBLY 4INSTALLING BELT COVERS 3INSTALLING DRIVE BELT6INSTALLING MIDDLE CHUTE 5TRIMMING MIDDLE CHUTE7INSTALLING BAGGER MOUNT 8INSTALLING CHUTE SUPPORT ASSEMBLY9INSTALLING WEIGHT KITS 10MOUNTING COVER ASSEMBLYTIPS FOR IMPROVED BAGGING 11INSTALLING SPACER PLUGSOPERATION STORAGEGENERAL RECOMMENDATIONS Blower Assembly REPAIR PARTSITEM PART NO DESCRIPTIONChute Assembly REPAIR PARTSITEM PART NO DESCRIPTIONREPAIR PARTS DESCRIPTION HUSQVARNA PRODUCT REGISTRATION INFORMATION & WARRANTY STATEMENT SECTION 3 ITEMS NOT COVERED BY THIS WARRANTY SECTION 2 HUSQVARNAS OBLIGATIONS UNDER THE WARRANTYSECTION 6 PROCEDURE TO OBTAIN WARRANTY CONSIDERATION SECTION 4 EXCEPTIONS AND LIMITATIONS01/22/09 P/N 115 145127 IR
Top Page Image Contents