Husqvarna 966004501, 2009-01 manual Operation, Storage, General Recommendations

Page 12
OPERATION

OPERATION

If the grass catcher fails to pick up cut grass or leaves, it is an indication that clogging has occurred in the system or that the grass catcher containers are full.

a.Disengage blades, place motion control levers in neutral position.

-Unlatch and raise cover.

-Slide out containers and dispose of clippings.

-Replace containers, close cover, and latch.

b.Unlatch chutes and check for clogging.

-Remove all debris in chute.

-Reassemble and latch chutes.

STORAGE

When grass catcher is to be stored for a period of time, clean it thoroughly, remove all dirt, grass, leaves, etc. Store in a clean, dry place.

CAUTION

Do not leave grass in bagger containers. Empty containers after each use and before storing. Failure to do so may result in spontaneous combustion which could develop into a fire.

GENERAL RECOMMENDATIONS

Always observe safety rules when performing any maintenance.

Before each use check for loose fasteners.

Clean unit thoroughly after each use.

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

See BLADE CARE instructions in your mower operator’s manual.

CAUTION

BEFORE PERFORMING

MAINTENANCE, SERVICE OR

ADJUSTMENTS:

Set parking brake.

Place motion control levers in “NEUTRAL” position.

Place clutch control in “DISENGAGED” position.

Turn ignition key to “OFF” position.

Make sure blades and all moving parts have completely stopped.

Disconnect spark plug wire(s) from spark plug(s) and place wire where it cannot come in contact with plug.

CAUTION

Grass catcher components are subject to wear, damage and deterioration, which could expose moving parts or allow objects

to be thrown. Frequently check components and replace with manufacturer’s recommended parts, when necessary.

CAUTION

DO NOT operate mower with grass catcher partially installed.

Disengage blades and stop engine before leaving mower seat to empty containers, unclogging chutes, etc.

Close cover before starting.

Disengage mower blades when crossing driveways or gravel surfaces and other areas where thrown objects could be a hazard.

DO NOT attempt to vacuum cans or other potentially hazardous projectiles.

13

Image 12
Contents Operators Manual 2009-01Operators Manual Blower Kit - 48 Collection SystemCONTENTS KNOW YOUR BLOWER SYSTEMSAFETY RULES DANGERSAFE OPERATION PRACTICES FOR RIDE-ON MOWERS GENERAL OPERATIONSERVICE CHILDRENDO NOT NEVER allow children to operate the machineNever make adjustments or repairs with the engine running CONTAINER CONTENTS UNPACKING INSTRUCTIONSTOOLS REQUIRED ASSEMBLY 1INSTALLING DRIVE PULLEY2MOUNTING BLOWER ASSEMBLY 3INSTALLING DRIVE BELT 4INSTALLING BELT COVERS6INSTALLING MIDDLE CHUTE 5TRIMMING MIDDLE CHUTE7INSTALLING BAGGER MOUNT ASSEMBLY 8INSTALLING CHUTE SUPPORT9INSTALLING WEIGHT KITS 10MOUNTING COVER ASSEMBLY11INSTALLING SPACER PLUGS TIPS FOR IMPROVED BAGGINGOPERATION STORAGEGENERAL RECOMMENDATIONS REPAIR PARTS Blower AssemblyDESCRIPTION ITEM PART NOREPAIR PARTS Chute AssemblyDESCRIPTION ITEM PART NOREPAIR PARTS REPAIR PARTS HUSQVARNA PRODUCT REGISTRATION INFORMATION & WARRANTY STATEMENT SECTION 2 HUSQVARNAS OBLIGATIONS UNDER THE WARRANTY SECTION 3 ITEMS NOT COVERED BY THIS WARRANTYSECTION 6 PROCEDURE TO OBTAIN WARRANTY CONSIDERATION SECTION 4 EXCEPTIONS AND LIMITATIONSP/N 115 145127 IR 01/22/09