Husqvarna 380BTS/BFS Your Warranty Rights and Obligations, MANUFACTURER’S WAR- Ranty Coverage

Page 2

English

FEDERAL EMISSION CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The EPA (The US Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and Husqvarna Forest & Garden are pleased to explain the emissions control system warranty on your 2007 and later small nonroad engine. In U.S. and Canada, new small nonroad engines must be designed, built and equipped to meet the federal stringent anti- smog standards. Husqvarna Forest & Garden must warrant the emission control system on your small nonroad engine for the period of time listed below provided there has been no abuse, neglect or improper maintenance of your unit. Your emission control system includes Parts such as the carburetor, fuel tank and the ignition system. Where a warrantable condition exists, Husqvarna Forest & Garden will repair your small nonroad engine at no cost to you. Expenses covered under warranty include diagnosis, parts and labor.

MANUFACTURER’S WAR- RANTY COVERAGE

The 2007 and later small nonroad engines are warranted for two years. If any emission related part on you engine (as listed above) is defective, the part will be repaired or replaced by Husqvarna Forest & Garden.

responsibilities, you should contact your nearest authorized servicing dealer or call Husqvarna Forest & Garden at 1-800-487-5963.

WARRANTY PERIOD Any warranted part which is not scheduled for replacement as required maintenance, or which is scheduled only for regular inspection to the effect of “repair or replace as necessary” shall be warranted for 2 years. Any warranted part which is scheduled for replacement as required maintenance shall be warranted for the period of time up to the first scheduled replacement point for that part.

DIAGNOSIS The owner shall not be charged for diagnostic labor which leads to the determination that a warranted part is defective, if the diagnostic work is performed at an approved Husqvarna Forest & Garden servicing dealer.

CONSEQUENTIAL DAMAGES Husqvarna Forest & Garden may be liable for damages to other engine components caused by the failure of a warranted part still under warranty.

WHAT IS NOT COVERED

All failures caused by abuse, neglect or improper maintenance are not covered.

OWNER’S WARRANTY

RESPONSIBILITIES

As the small nonroad engine owner, you are responsible for the performance of the required maintenance listed in your Operator’s Manual. Husqvarna Forest & Garden recommends that you retain all receipts covering maintenance on your small nonroad engine, but Husqvarna Forest & Garden cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small nonroad engine owner, you should, however, be aware that Husqvarna Forest & Garden may deny you warranty coverage if your small nonroad engine or a part of it has failed due to abuse, neglect, improper maintenance, unapproved modifications or the use of parts not made or approved by the original equipment manufacturer. You are responsible for presenting your small nonroad engine to a Husqvarna Forest & Garden authorized servicing dealer as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. If you have any questions regarding your warranty rights and responsibilities, you should contact your nearest authorized servicing dealer or call Husqvarna Forest & Garden at 1-800-487-5963.

WARRANTY COMMENCE- MENT DATE

The warranty period begins on the date small nonroad engine is delivered.

LENGTH OF COVERAGE

Husqvarna Forest & Garden warrants to the initial owner and each subsequent purchaser that the engine is free from defects in materials and workmanship which cause the failure of a warranted part for a period of two years.

WHAT IS COVERED

REPAIR OR REPLACEMENT OF PARTS Repair or replacement of any warranted part will be performed at no charge to the owner at an approved Husqvarna Forest & Garden servicing dealer. If you have any questions regarding your warranty rights and

ADD -ON OR MODIFIED PARTS

The use of add-on or modified parts can be grounds for disallowing a warranty claim. Husqvarna Forest & Garden is not liable to cover failures of warranted parts caused by the use of add-on or modified parts.

HOW TO FILE A CLAIM

If you have any questions regarding your warranty rights and responsibilities, you should contact your nearest authorized servicing dealer or call Husqvarna Forest & Garden at 1-800-487-5963.

WHERE TO GET WARRANTY SERVICE

Warranty services or repairs shall be provided at all Husqvarna Forest & Garden authorized servicing dealers.

MAINTENANCE, REPLACE- MENT AND REPAIR OF EMIS- SION-RELATED PARTS

Any Husqvarna Forest & Garden approved replacement part used in the performance of any warranty maintenance or repairs on emission-related parts, will be provided without charge to the owner if the part is under warranty.

EMISSION CONTROL WAR- RANTY PARTS LIST

1Carburetor and internal parts

2Intake pipe, airfilter holder and carburetor bolts.

3Airfilter and fuelfilter covered up to maintenance schedule.

4Ignition System

1Spark Plug, covered up to maintenance schedule 2Ignition Module

5Fuel tank with cap and pipe

MAINTENANCE STATEMENT

The owner is responsible for the performance of all required maintenance, as defined in the operator’s manual.

2

Image 2
Contents 380BTS/BFS English Applicable Serial Numbers 80100101 and upOWNER’S Warranty Responsibilities Your Warranty Rights and ObligationsWhat is not Covered Warranty COMMENCE- Ment DateContents Symbols SafetySafety First For EPA & Carb Symbols on the machineSafety Precautions ModelWorking Circumstance Avoid Noise ProblemWorking Conditions Working PlanBefore Starting the Engine Using the ProductTemperature of the machine may increase after stopping 330BT 350BT/BF 370BTS/BFS 380BTS/BFSStorage MaintenanceTransportation „ Disposal What is what?330BT 350BT/BF 350BT 350BF370BTS/BFS 370BTS 370BFS380BTS/BFS 380BTS 380BFSModel 330BT 350BT 350BF 370BTS 370BFS 380BTS 380BFS„ Right Handle 350BF/370BFS/380BFS Assembly„ Swivel Joint „ Handlebar Option 330BT/350BT/370BTS/ 80BTS3330BT has no waist belt „ Blower Tubes„ Harness „ Fuel „ HOW to MIX FuelFuel „ Fueling the Unit„ Starting Engine Operation„ Control ARM 350BF/370BFS/380BFS „ Adjusting Idle Speed „ Stopping EngineCleaning AIR Filter Maintenance„ AIR Cleaner „ Muffler „ Fuel Filter„ Spark Plug „ Spark Arrester„ Ignition Coil AIR GAP Inspection Storage„ AIR Inlet NET „ Sholder Strap