Husqvarna 350BT/BF Storage, „ AIR Inlet NET, „ Ignition Coil AIR GAP Inspection, „ Sholder Strap

English

Maintenance

„AIR INLET NET

IMPORTANT

•Blown air is taken in from the air inlet net. If the air flow drops during operation, stop the engine and inspect the air inlet net for blockage by obstacles.

•Note that failure to remove any such obstacles may result in the engine becoming overheated and damaged.

(1)Net

WARNING

Never use the blower without the net on the blower. Before each use, check that the net is attached in place and is free from any damage.

„IGNITION COIL AIR GAP INSPECTION

•If the gap is not accurate or when installing the coil or rotor, adjust the air gap between the ignition coil and the iron core of the rotor.

Air Gap: [330BT]		[350BT/BF] [370BT/BF] [380BT/BF]
0.35 mm (0.30 to 0.40 mm)		0.40 mm (0.35 to 0.45 mm)
0.014 in	(0.012 to 0.016 in)	0.016 in (0.014 to 0.017 in)

(1)Rotor

(2)Ignition coil

F36

(1)

[330BT]

F37

(1)

[350BT/BF] [370, 380BTS/BFS]

F38

(2)

(1)

[330BT]

F39

[350BT/BF] [370, 380BTS/BFS]

„SHOLDER STRAP

•If the shoulder strap is damaged it may break during use, thus causing the product to fall and resulting in personal injury. Follow the instructions below to replace the shoulder strap with new one.

•Take off the clip from the strap.

•Pass the end of the strap through the hanger.

•Return the clip to the strap.

IMPORTANT

F40

Make sure that the thick round bar of the clip is in the strap.

If it is attached in the wrong way, it leads to serious personal injury.

Storage

BEFORE STORING THE BLOWER:

1.Drain the fuel tank and push the primer bulb until it becomes empty of fuel.

2.Remove the spark plug and drop a spoonful of 2-cycle oil into the cylider. Crank the engine several time and install the spark plug.

3.Store unit in a dry, cool and dark, well-ventilated, dust-free place, out of the reach of children.

21