English
Assembly
■FLEXIBLE HOSE AND SWIVEL JOINT
1.Connect the blower and swivel joint with flexible hose. Clamp both ends of the flexible hose securely with the hardware supplied with the unit.
(1) | Flexible hose | (2) | Swivel joint |
(3) Clamp (large) | (4) | Clamp (small) | |
NOTE
A light lubricant may be used to ease assembly of flexible hose to blower elbow.
■CONTROL HANDLE [130BT/350BT/370BTS/380BTS]
1.Set up the handle holder to the swivel joint and tighten the knob on the holder.
When setting up the handle holder, please make sure to match the handle holder to the convex on the swivel joint as shown in F2.
2.Adjust the position and angle to achieve a comfortable working position, and tighten the control handle.
(1)Cabling
(2)Flexible hose
■CABLING [130BT/350BT/370BTS/380BTS]
[130BT]
- Fasten the cabling at central position of the hose by the band attached to the cabling.
First, wrap the flexible hose with the band fixed to the cabling from the lower side.
Then, pass the band through a hole of the band as shown in figure. Please note that there is a possibility of damaging the hose if the band is fastened too tightly.
[350BT] [370BTS] [380BTS]
-Use the clamp to fasten the cabling to the flexible hose.
(1)Clamp
■RIGHT HANDLE [350BF/370BFS/380BFS]
-Insert the handle holder to the swivel and tighten the knob on the holder.
When setting up the holder, please make sure to match the holder to the convex on the swivel joint as shown in F5.
■HANDLEBAR [OPTION] [130BT/350BT/370BTS/
380BTS]
1.Insert the holder, then assemble the handlebar (OPTION) and tighten it securely.
F1
(3)
(1)
(4)(2)
F2 |
(2) |
(1) |
F3 |
[130BT] |
F4 |
(1) |
[350BT] [370BTS] [380BTS] |
F5 |
F6 |
14