English
Operation
STARTING ENGINE
IMPORTANT
•Avoid operating the blower with the flexible tube and swivel joint disconnected. That will reduce the cooling air and the engine could be damaged by overheating.
1.Push the primer bulb until fuel flows out in the clear tube.
2.When the engine is cool, close the choke.
(1)Choke Lever
(2)Primer Bulb
(3)OPEN
(4)CLOSE
3. Set the throttle lever position.
[130BT] | [150BT] [170BT] [180BT] |
Idling | About 1/3 Open |
(1)Full Throttle
(2)About 1/3 Open
(3)Idling
(4)STOP
4.To start, hold the top of the blower firmly with your left hand. Pull the starter knob slowly until you feel it engage and then give it a vigorous strong pull.
IMPORTANT
•Never twist the starter cord around your hand.
•Avoid pulling the starter rope out to its full extent and allowing the starter rope to snap back. This will prevent premature damage to the starter.
•Do not let a person stand near the blower or the exhaust port.
5.Once the engine is running, gradually open the choke if it was set closed, and let the engine run at idle speed for a minute to warm it up.
NOTE
When the engine fails to start after several attempts due to overchoking, open the choke and repeat pulling the rope.
WARNING
Air comes out as soon as the engine is started, even at idle speed.
F13 | (1) |
| (4) |
| (3) |
(2) | [130BT] |
F14 | (1) |
| |
| (3) |
| (4) |
(2) | [150BT] |
F15 | (1) |
| (3) |
| (4) |
(2) | [170BT] [180BT] |
|
F16 | (2) |
(3) | |
(4) | (1) |
|
F17
18