Husqvarna SPM1702SM manual Fitting the trimmer guard and trimmer head, Guard

Page 12

ASSEMBLY

Fitting the trimmer guard and trimmer head

(325Cx)

Guard

•Fit the guard as shown in the diagram. Tighten securely.

Trimmer head

•Fit the dust cup on the shaft. The nut must be completely covered by the dust cup.

•Hold the dust cup with a spanner to prevent the shaft from rotating.

•Screw the trimmer head onto the shaft.

12 – English

Image 12

Contents 323L 323LD 325CX 325LX 325LDX KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Stop switchThrottle lockout Cutting attachment guard Vibration damping systemMufﬂer Cutting equipment Locking nutTrimmer head Assembly AssemblyFitting the loop handle Assembling and dismantling the two-piece shaftAssembling the cutting equipment Fitting other guards and cutting attachmentsFitting the trimmer guard and trimmer head GuardFuel safety Fuel HandlingFuel Fuelling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping Basic safety rules Working TechniquesGeneral working instructions Basic working techniquesGrass trimming with a trimmer head TrimmingMaintenance CarburettorFine adjustment of the idle speed T Correctly adjusted carburettorMufﬂer High speed jet HCleaning the air ﬁlter Cooling systemSpark plug Two-piece shaftOiling the air ﬁlter Bevel gearMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataTechnical data 325Cx 325Lx 325LDx Engine Approved accessories Art No Use with EC-declaration of conformity Applies to Europe only EN292-2, Cispr 121997, EN ISO095 ~2,0 m Page 10 cm Clic 15 cm 095-.106 25 m10 cm 15 cm Clic 10 cm 05 m 15 cm Clic 079-0.095 75 m2,4 mm 079-0.095 75 m x Clic 1150257-26 ´z+R9h¶6¢¨ ´z+R9h¶6¢¨