Husqvarna 327LDX manual Starting and Stopping, Check before starting, Starting and stopping

Page 14

STARTING AND STOPPING

Check before starting

Check that the support flange is not cracked due to fatigue or due to being tightened too much. Discard the support flange if it is cracked.

Ensure the locking nut has not lost its captive force. The nut lock should have a locking force of at least 1.5 Nm. The tightening torque of the locking nut should be 35-50 Nm.

Check that the trimmer head and trimmer guard are not damaged or cracked. Replace the trimmer head or trimmer guard if they have been exposed to impact or are cracked.

Never use the machine without a guard nor with a defective guard.

All covers must be correctly fitted and undamaged before you start the machine.

14 – English

Starting and stopping

WARNING! The complete clutch cover

!and shaft must be fitted before the machine is started, otherwise the clutch can come loose and cause personal injury.

Always move the machine away from the refuelling area before starting. Place the machine on a flat surface. Ensure the cutting attachment cannot come into contact with any object.

Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury.The safety distance is 15 metres.

Starting

Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled.

Choke: Set the choke control in the choke position.

WARNING! When the engine is started

! with the choke in either the choke or start throttle positions the cutting attachment will start to rotate immediately.

Hold the body of the machine on the ground using your left hand (CAUTION! Not with your foot!). Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord. Never wrap the

starter cord around your hand

Repeat pulling the cord until the engine starts. When the engine starts. return choke control to run position and apply full throttle; the throttle will automatically disengage from the start setting.

Image 14
Contents 327LDX-series Operator of the machine must Ensure, while working, that no KEY to SymbolsSymbols Persons or animals come closerContents Introduction Dear customerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard MufflerCutting equipment Trimmer headFitting the loop handle AssemblyAssembly Assembling and dismantling the two-piece shaftAssembling the cutting equipment Fitting the trimmer guard and trimmer headFuel Fuel safetyFuel Handling Fueling MixingStarting and stopping Starting and StoppingCheck before starting StartingStopping General working instructions Basic safety rulesWorking Techniques Basic working techniques Grass trimming with a trimmer headMaintenance CarburetorLow speed jet L Fine adjustment of the idle speed TCorrectly adjusted carburetor High speed jet HRemember the risk of fire MufflerCooling system Two-piece shaft Cleaning the air filterSpark plug Air filterOiling the air filter Bevel gearMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataPowerhead model Accessories Art No Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page 1151209-95