Husqvarna 327LDX Assembling the cutting equipment, Fitting the trimmer guard and trimmer head

Page 11

ASSEMBLY

Assembling the cutting equipment

WARNING!

! When ﬁtting the cutting attachment it is extremely important that the raised section on the drive disc/support ﬂange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is ﬁtted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is ﬁtted this can cause serious personal injury.

Fitting the trimmer guard and trimmer head

•Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the ﬁtting on the shaft and secure with the bolt (L).

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.

H

H

•To dismantle, follow the instructions in the reverse order.

English – 11

Image 11

Contents 327LDX-series Persons or animals come closer KEY to SymbolsSymbols Operator of the machine must Ensure, while working, that noContents Dear customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentMufﬂer Stop switchCutting attachment guard Vibration damping systemTrimmer head Cutting equipmentAssembling and dismantling the two-piece shaft AssemblyAssembly Fitting the loop handleFitting the trimmer guard and trimmer head Assembling the cutting equipmentFuel Fuel safetyFuel Handling Mixing FuelingStarting Starting and StoppingCheck before starting Starting and stoppingStopping General working instructions Basic safety rulesWorking Techniques Grass trimming with a trimmer head Basic working techniquesCarburetor MaintenanceHigh speed jet H Fine adjustment of the idle speed TCorrectly adjusted carburetor Low speed jet LRemember the risk of ﬁre MufﬂerCooling system Air ﬁlter Cleaning the air ﬁlterSpark plug Two-piece shaftBevel gear Oiling the air ﬁlterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataPowerhead model Accessories Art No Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page 1151209-95