Husqvarna 327LDX manual Basic working techniques, Grass trimming with a trimmer head

Page 17

WORKING TECHNIQUES

Basic working techniques

Always slow the engine to idle speed after each working operation. Long periods at full throttle without any load on the engine can lead to serious engine damage.

WARNING! Sometimes branches or

! grass get caught between the guard and cutting attachment. Always stop the engine before cleaning.

Grass trimming with a trimmer head

Trimming

Hold the trimmer head just above the ground at an angle. It is the end of the cord that does the work. Let the cord work at its own pace. Never press the cord into the area to be cut.

The cord can easily remove grass and weeds up against walls, fences, trees and borders, however it can also damage sensitive bark on trees and bushes, and damage fence posts.

Reduce the risk of damaging plants by shortening the cord to 10-12 cm and reducing the engine speed.

Clearing

The clearing technique removes all unwanted vegetation. Keep the trimmer head just above the ground and tilt it. Let the end of the cord strike the ground around trees, posts, statues and the like. CAUTION! This technique increases the wear on the cord.

The cord wears quicker and must be fed forward more often when working against stones, brick, concrete, metal fences, etc., than when coming into contact with trees and wooden fences.

When trimming and clearing you should use less than full throttle so that the cord lasts longer and to reduce the wear on the trimmer head.

Cutting

The trimmer is ideal for cutting grass that is difficult to reach using a normal lawn mower. Keep the cord parallel to the ground when cutting. Avoid pressing the trimmer head against the ground as this can ruin the lawn and damage the tool.

Do not allow the trimmer head to constantly come into contact with the ground during normal cutting. Constant contact of this type can cause damage and wear to the trimmer head.

Sweeping

The fan effect of the rotating cord can be used for quick and easy clearing up. Hold the cord parallel to and above the area to be swept and move the tool to and fro.

When cutting and sweeping you should use full throttle to obtain the best results.

English 17

Image 17
Contents 327LDX-series Symbols KEY to SymbolsOperator of the machine must Ensure, while working, that no Persons or animals come closerContents Dear customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system MufflerTrimmer head Cutting equipmentAssembly AssemblyFitting the loop handle Assembling and dismantling the two-piece shaftFitting the trimmer guard and trimmer head Assembling the cutting equipmentFuel Fuel safetyFuel Handling Mixing FuelingCheck before starting Starting and StoppingStarting and stopping StartingStopping General working instructions Basic safety rulesWorking Techniques Grass trimming with a trimmer head Basic working techniquesCarburetor MaintenanceCorrectly adjusted carburetor Fine adjustment of the idle speed TLow speed jet L High speed jet HRemember the risk of fire MufflerCooling system Spark plug Cleaning the air filterTwo-piece shaft Air filterBevel gear Oiling the air filterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataPowerhead model Accessories Art No Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page 1151209-95