ASSEMBLY
The guard extension is removed easily using the spark plug spanner, see illustration.
Fitting a blade guard, grass blade and grass cutter
Fitting other guards and cutting attachments
•Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. CAUTION! Ensure that the guard extension is fitted.
Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.
A
A
GF
E
D
B
C
L 
M
C
A
•Fit the drive disc (B) on the output shaft.
H
•Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt.CAUTION! Ensure that the guard extension is removed.
Use the recommended blade guard. See the Technical data section.
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Place the blade (D), support cup (E) and support flange (F) on the output shaft.
•Fit the nut (G). The nut must be tightened to a torque of
B
A
C
M L
• Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.
H
H
•To dismantle, follow the instructions in the reverse order.
English – 13