Husqvarna 325RXT-Series, 323R, 325RX-Series, 325RDX-Series manual Cutting equipment

Page 9

SAFETY INSTRUCTIONS

6. Cutting equipment

This section describes how through correct maintenance and through using the right type of cutting equipment you can:

•Reduce the machine‘s tendency to kickback

•Obtain maximum cutting capacity.

•Increase the service life of the cutting equipment.

Four basic rules:

1)Only use the cutting and guard equipment we recommend! See chapter “Technical data“.

2)Keep the blade‘s teeth well and correctly sharpened! Follow our instructions and use the recommended filing gauge. An incorrectly sharpened or damaged blade increases the risk of an accident.

3)Keep the correct setting. Follow our instructions and use the recommended setting tool. An incorrectly set blade increases the risk of jamming and kickback.

4)Check the cutting equipment with regard to damage and crack formation. Damaged cutting equipment should always be replaced.

7. Quick-release

• Check that the harness straps are correctly positioned. When the harness and machine are adjusted, check the harness‘ safety release catch to ensure it works correctly.

8. Locking nut

• Protect your hand from injury when assembling, use the blade guard as protection when tightening with a socket spanner. Tighten the nut by turning against the direction of rotation. Loosen the nut by turning in the direction of rotation. (NOTE! the nut has a left-hand thread).

•Tighten the nut using a socket spanner, 35 - 50 Nm (3.5 - 5 kpm).

NOTE!

The locking nut‘s nylon lock must not be so worn that it can be turned by hand. The lock shall hold at least 1.5 Nm. The nut should be replaced after it has been put on approx. 10 times.

!WARNING!

Never use a machine with defective safety equipment. The safety equipment should be maintained as described in this section. If your machine does not meet any of these controls you should contact your service workshop.

English – 9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents 323R 325RX-SERIES Symbols Symbol ExplanationContents Machine‘s safety equipment Safety InstructionsPersonal protective equipment Throttle trigger lockCutting attachment guard Stop switchAnti-vibration system Quick-releaseMuffler Cutting equipmentLocking nut Throttle trigger lock Vibration damping system Cutting equipment Sharpening Cutting equipmentGrass blade Trimmer headFuel safety General safety instructionsStart Transport and storageGeneral working instructions Basic safety precautionsAdjusting the harness and clearing saw Basic clearing techniquesDesignations Brush cutting using the saw blade Grass clearing using a grass bladeClearing‘s ABC Working methodsClearing Grass clearing using the trimmer head and plastic bladesTrimming SweepingWhat is what on the brushcutter? What is WHAT?Assembling the handlebars 323R AssemblyGrass blade Guard. See Technical DataFit the appropriate guard Adjusting the harness and clearing saw AssemblingDismantling Fuel Handling Fuel mixtureFuelling Control before starting Start and StopStart and stop Cold engineFor throttle handles with a start throttle lock StopStart Carburetor MaintenanceCorrectly adjusted carburetor Final setting of the idling speed TAdjusting the start throttle speed High speed needleCooling system MufflerAngle gear Two-part shaftAir filter Spark plug Filing the grass bladeOiling the air filter Daily maintenance Maintenance scheduleWeekly maintenance Monthly maintenanceTechnical data 323R 325RX Technical DataGuard Art No Approved accessories 323R Type Cutting attachmentYour Warranty Rights Obligations Emission Control Warranty StatementSuper Auto Super Auto II Tri Cut Trimmy H Click Trimmy Hit Junior Trimmy Hit Pro 12 cm Trimmy SII English Page ´+H*G¶5q¨ Page 2002W13 114 01 03
Top Page Image Contents