Husqvarna 325RXT-Series manual Adjusting the harness and clearing saw, Assembling, Dismantling

Page 20

ASSEMBLY

Assembling and dismantling the two-part shaft (325RXT, 325RDX)

Assembling:

• Make sure the handle is loose.

• Guide the cut-out on the lower section of the shaft into the coupling‘s locking plate on the upper section of the shaft. The sections are then locked together.

• Tighten the handle.

Dismantling

• Undo the handle (at least three turns).

•Press the handle towards the coupling.

• Carefully twist the lower section out of the lock.

•Hold both parts of the shaft and pull out the lower section from the coupling.

20 – English

Adjusting the harness and clearing saw

!WARNING!

When working with the clearing saw it should always be hooked in the harness. If this is not done, you cannot control the clearing saw safely and this can result in injury to yourself or someone else. Never use a harness with a defective quick release catch.

Quick release

On the front is an easily accessible, quick release catch. Use this if the engine should catch fire or in any other emergency situation when you quickly need to take off the harness and machine.

Even load on the shoulders

A well-adjusted harness and clearing saw significantly facilitates working. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across the shoulders.

Correct height

Adjust the support strap so that the cutting attachment is parallel to the ground.

Correct balance The cutting attachment should rest lightly on the ground. If you use a saw blade it should balance about 10 cm above the ground to prevent contact with stones and the like. Adjust the position of the support strap attachment ring to balance the clearing saw correctly.

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 323R 325RX-SERIES Symbol Explanation SymbolsContents Safety Instructions Machine‘s safety equipmentPersonal protective equipment Throttle trigger lockStop switch Cutting attachment guardAnti-vibration system Quick-releaseLocking nut MufflerCutting equipment Throttle trigger lock Vibration damping system Cutting equipment Cutting equipment SharpeningGrass blade Trimmer headGeneral safety instructions Fuel safetyStart Transport and storageBasic safety precautions General working instructionsDesignations Adjusting the harness and clearing sawBasic clearing techniques Grass clearing using a grass blade Brush cutting using the saw bladeClearing‘s ABC Working methodsGrass clearing using the trimmer head and plastic blades ClearingTrimming SweepingWhat is WHAT? What is what on the brushcutter?Assembly Assembling the handlebars 323RGuard. See Technical Data Grass bladeFit the appropriate guard Dismantling Adjusting the harness and clearing sawAssembling Fuelling Fuel HandlingFuel mixture Start and Stop Control before startingStart and stop Cold engineStart For throttle handles with a start throttle lockStop Maintenance CarburetorFinal setting of the idling speed T Correctly adjusted carburetorAdjusting the start throttle speed High speed needleMuffler Cooling systemAngle gear Two-part shaftOiling the air filter Air filter Spark plugFiling the grass blade Maintenance schedule Daily maintenanceWeekly maintenance Monthly maintenanceTechnical Data Technical data 323R 325RXApproved accessories 323R Type Cutting attachment Guard Art NoEmission Control Warranty Statement Your Warranty Rights ObligationsSuper Auto Super Auto II Tri Cut Trimmy H Click Trimmy Hit Junior Trimmy Hit Pro 12 cm Trimmy SII English Page ´+H*G¶5q¨ Page 114 01 03 2002W13
Top Page Image Contents