Standard harness

ASSEMBLY

Cable adjustment

•Throttle cable should be paralleled to ﬂexible shaft. In case of twisting, they should be restored by parallel.

•Throttle cable should be adjusted under the bended ﬂexible shaft.

1Loosen the lock-nut (C) and adjust the cable adjuster sleeve (D) so the stop on the carburettor throttle cam just contacts the throttle stop and the cable position keep 1–2 mm play between cable lug and slotted ﬁttings when the throttle trigger is fully depressed.

2When the throttle cable is adjusted correctly, tighten the locking nut (C).

1-2mm

Adjusting the harness and clearing saw

WARNING! When using a clearing saw it

!must always be hooked securely to the harness. Otherwise you will be unable to control the clearing saw safely and this can result in injury to yourself or others. Never use a harness with a defective quick release.

Quick release

At the front is an easily accessible, quick release. Use this if the engine catches ﬁre or in any other emergency situation that requires you to free yourself from the machine and harness.

Spreading the load on your shoulders

A well-adjusted harness and machine makes work much easier. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across both shoulders.

Correct height

Adjust the shoulder strap so that the cutting attachment is parallel to the ground.

Correct balance

Let the cutting attachment rest lightly on the ground. Adjust the position of the support hook to balance the clearing saw correctly.

English – 15