Using the Controls

		Air Controls
	Display
Temp	Pump	Light	Temp
Up	Button	Button	Down

Refer to the diagram above. The function of each control is explained below:

Temperature Buttons: Control the temperature setting of the water. The temperature can be set from 80°F to 104°F. The water heats at about 6°F per hour with the cover on. Use a medical or other accurate thermome- ter to check the temperature of the water.

To change the water temperature, push either the temp up or temp down button until the desired tem- perature is reached.

If the letters OH, FL, or Sn appear in the display, refer to page 17.

Pump Button: Turns the spa jets on and off. This is a two-speed button. If the button is pressed once, the spa jets will run at low speed, providing gentle hydrotherapy. If the button is pressed twice, the spa jets will run at high speed, providing moderate-pres- sure hydrotherapy. If the button is pressed again, the jets will shut off.

The spa also features an automatic mode that heats and filters the water when the spa is left unattended. When the power to the spa is first turned on, or if the water temperature is below the set temperature, the water will be heated as required to maintain the set temperature. Note: To keep the filter and heat cycles from running, the power to the spa must be turned off.

Light Button: Turns the underwater light on and off.

Air Controls: Determine the amount of air flowing through the spa jets. If a control is turned counter- clockwise, the amount of air flowing through the jets will increase; if a control is turned clockwise, the amount of air will decrease. Test each of the air con- trols to determine which jets are controlled by which air control.