3.The hydrotherapy spa operates on a
Under no circumstances should the spa be wired by someone other than a qualified electrician. Before you have the spa wired, make sure it is in the desired position, and that it can be easily serviced, if needed.
4.Remove the two warning decals (not shown) from the spa shell. Using a damp cloth, wipe the spa shell clean. Before filling the spa, make sure that it is in the desired position and that there is room to service the spa. Once the spa is filled, it will have to be drained before it can be moved.
Remove the filter cap, basket, diverter, cartridge plug, and filter cartridge.
Insert a garden hose into the filter housing and fill the spa. Do not use soft water. The spa may be filled with cold water; however, if warm or hot water is used, the spa will be ready for use sooner. Fill the spa until the water is at the middle of the filter housing door (not shown). Do not overfill the spa.
Insert the filter cartridge, cartridge plug, diverter, and basket into the filter housing. Cover the filter housing with the filter cap.
5.Pull down one of the straps on the Spa Cover (11) and hold the Buckle (26) against one of the premium cedar panels on the spa. (Note: To position the Buckle correctly, have a second person hold the strap on the opposite side of the Spa Cover snug.) The Spa
Cover must be snug. Do not place the Buckle over the grooves between the panels. Refer to the inset drawing. Remove the latch from the Buckle (26). Attach the Buckle to the premium cedar panel with two #4 x 3/4” Screws (27).
Attach the other three Buckles (26) to the panels in the same way.
Remove the Spa Cover (11) from the spa.
4 | Filter |
|
|
| |
| Cap |
|
Water Level | Basket |
|
| Diverter |
|
| Cartridge | Filter |
| Plug | Cartridge |
| Filter |
|
| Housing |
|
Garden | Filter |
|
Hose |
| |
Housing |
| |
|
|
5 |
Strap |
11 |
Latch |
26 |
27 |
Strap |
26 |
9