Maintenance

Cartridge

Plug

Filter

Housing

Filter

Cap

Basket

Diverter

Filter

Cartridge

The hydrotherapy spa is designed to provide years of enjoyment. Please follow the guidelines below to properly maintain your spa.

MAINTENANCE SCHEDULE

Daily

•Check the water level and refill the spa to the level shown in step 4 on page 9.

•Check the pH balance and sanitizer level. Adjust if necessary (see WATER CHEMISTRY on page 14).

Weekly

•Clean the spa shell at the waterline.

•Check and thoroughly clean the filter (see CHECK- ING AND CLEANING THE FILTER CARTRIDGE on this page).

•Replace the filter cartridge if needed (see ORDER- ING REPLACEMENT PARTS on the back cover).

Monthly

•Clean the spa cover (see MAINTAINING THE SPA COVER on this page).

•Soak the filter for two hours in a trisodium phos- phate (TSP) solution. Rinse the filter in clean water.

•Replace the filter if needed (see ORDERING REPLACEMENT PARTS on the back cover).

Every Three Months

•Drain the spa and refill it with clean water. Sanitize and test the pH of the water.

•Check for any leaks around the pump or joints in the pipes. The seals will wear out over time; detect- ing leaks early can reduce repair costs.

•Clean the interior of the spa. Do not use solvents or waxes.

MAINTAINING THE SPA EXTERIOR

The premium cedar surround has been treated at the factory. For information and supplies to maintain the beauty and color of the premium cedar surround, con- tact your local pool and spa supply store.

CLEANING THE SPA SHELL

The spa shell should be cleaned with a mild soap solution; do not use solvents. The spa should always be clean and dry before being moved or stored.

MAINTAINING THE SPA COVER

The spa cover should be cleaned monthly. To clean the spa cover, use water and a non-abrasive cleaner on the entire cover. Rinse the cover with a garden

hose to remove any cleaner residue. Dry the cover entirely. Use a non-silicone-based vinyl conditioner on the cover after you clean it. This will help protect the cover from sun damage.

CHECKING AND CLEANING THE FILTER CARTRIDGE

The filter cartridge should be checked periodically for build-up of dirt and oil. If the cartridge needs to be cleaned, follow the steps below:

1. Turn off the power.

2. Remove the filter

cover. 3. Remove basket,

diverter, cartridge plug, and filter car- tridge from the filter

housing.

4. Check the filter car-

tridge for dirt and debris. If the car-

tridge needs to be cleaned, rinse it with a hose. If the car- tridge is still dirty,

soak it in cleaning solution from a pool and spa supply store.

5.Inspect the filter cartridge for damage. Replace the cartridge if it is damaged.

6.Insert the cleaned or new filter cartridge into the fil- ter housing.

7.Re-attach the filter cover.

WATER CHEMISTRY

The maintenance of the pH level is very important to the operation of the spa. To maintain the proper pH level and to sanitize the spa, you can purchase a chemical starter kit from your local pool and spa sup- ply store.

CAUTION: The chemicals used to maintain the pH balance of the water and to sanitize the water can be dangerous. Always follow these basic guide- lines when handling the chemicals:

1.Always read and follow the directions on the label, unless directed otherwise.

2.Never mix different chemicals.

3.Do not exceed the recommended amounts of chemicals—follow the directions on the label closely.

4.Keep all chemicals out of the reach of children and pets.