Using the Controls
|
|
| Air Control L | Air Control M | Console |
|
|
|
|
| Display |
Temperature | Jet | Light | Temperature |
|
|
Up Button | Button | Button | Down Button |
|
|
Refer to the diagram above. The function of each control is explained below:
Temperature Buttons: Control the temperature setting of the water. The temperature can be set between 80°F and 104°F. The water heats at about 6°F per hour with the cover on. Use a medical or other accu- rate thermometer to check the temperature of the water. Note: The word “COOL” will appear in the con- sole display if the temperature of the water is more than 20°F cooler than the set temperature. When this happens, the heater will automatically activate to warm the water. The word “ICE” will appear in the display if the temperature drops below 40°F. If this happens, the pump will automatically circulate the water and warm the plumbing to keep the water from freezing.
Jet Button: Turns the spa jets on and off. This is a
The spa also features an automatic mode that heats and filters the water when the spa is left unattended. When the power to the spa is first turned on, or if the water temperature is below the set temperature, the water will be heated as required to maintain the set temperature. Note: To keep the filter and heat cycles from running, the power to the spa must be turned off.
Light Button: Turns the underwater light on and off.
Air Controls: Determine the amount of air flowing through the spa jets during operation. Refer to the diagram below. Air control M controls air flow to the jets labeled M. Air control L controls air flow to the jets labeled L. If the control is turned counterclockwise, the amount of air flowing through the jets will increase. If the control is turned clockwise, the amount of air will decrease.
L |
|
|
M | M | L |
| ||
| L |
|
|
| M |
|
| M |
12