Image IMSB61610, IMSG61610 user manual Clean. Before filling the spa, make sure that it is

3.Locate the three pillows. Each pillow can be attached to the spa shell in a high position or a low position. To determine the high and low positions, attach one pillow to the spa shell, note its position, remove it, turn it 180°, and then re-attach it. Attach the three pillows in the desired positions.

3	Pillow
Pillow	Pillow

4. The spa operates on a 240-volt power source and must be wired directly to a 30 amp Ground Fault Circuit
Interrupter (GFCI) installed in your home. This procedure must be performed by a qualified, licensed
electrician. A wiring diagram has been provided on the inside of the electronics package as a reference.
Under no circumstances should the spa be wired by someone other than a qualified electrician. Before
you have the spa wired, make sure that it is in the desired position and that it can be serviced, if needed.
5. Remove the two warning decals (not shown) from	5	8
the spa shell. Using a damp cloth, wipe the spa shell
		Water
clean. Before filling the spa, make sure that it is
		Level
in the desired position and that there is room to
		16
service the spa. Once the spa is filled, it will		Filter
have to be drained before it can be moved.
		Housing
Insert a garden hose into the filter housing, and
begin filling the spa. Do not use soft water. The
spa may be filled with cold water; however, if warm
or hot water is used, the spa will be ready for use		Filter
sooner. Fill the spa until the water is at the level of		Housing
the molded fill line. Do not overfill the spa.
Refer to the inset drawing. Set the Filter (16) in the
filter housing. Screw the Filter Cover (8) into the filter
housing until it is fully seated.
6. Pull down one of the straps on the Spa Cover (11)	6	11
and hold the Buckle (30) against one of the cedar
		Strap
panels on the spa. (Note: To position the Buckle cor-
rectly, have a second person hold the strap on the		Latch
opposite side of the Spa Cover tight.) The Spa
Cover must be tight. Do not place the Buckle		30
over the grooves between the cedar panels. Refer
to the inset drawing. Remove the latch from the
Buckle (30). Attach the Buckle to the cedar panel
with two #4 x 3/4” Screws (31).		31
Attach the other three Buckles (30) to the cedar pan-		Strap
els in the same way.
Remove the Spa Cover (11) from the spa.		30

9