8.After one minute, the current temperature of the water will be displayed. Push the temperature up or down button to set the temperature of the water. If the water temperature is below the set temperature, the heat indicator light will turn on to show that the water is being heated.
The controller will automatically heat the water and all of the features of the console will be avail- able. To use the console, see USING THE CON- TROLS on page 14.
9.Remove the towels and reattach the access panel (see ATTACHING AND REMOVING THE ACCESS PANEL on page 18).
TESTING AND TREATING THE WATER
The first time you use the spa, you should test and treat the water. You must also treat the water each time you refill the spa. A test strip and a chemical pack are available at your local pool and spa store. Follow the directions carefully on the chemical pack to test and treat the water. Always keep the chemicals away from children and pets.
Once you have tested the GFCI, verify that water is flowing from the jets. Set the air controls to the lowest setting (see USING THE CONTROLS on page 14). Cover the hydrotherapy spa with the spa cover. The spa cover must be tight (see SECURING THE SPA COVER ON THE SPA on this page). The water will heat at about 6°F per hour with the cover on. If you are using the spa indoors, and the room temperature is maintained at 70°F, it will take approximately 6 to 8 hours for the water to reach the set temperature.
The temperature and the water flow can be set or changed with the controls on the console (see USING THE CONTROLS on page 14).
USING THE CD PLAYER AND THE POP-UP SPEAKERS
See the included user’s manual for instructions on using the CD player. To use the
SECURING THE SPA COVER ON THE SPA
See WATER CHEMISTRY on page 17 for information concerning proper water maintenance.
STARTING THE HYDROTHERAPY SPA
You should always test the GFCI before using the hydrotherapy spa. First, turn on the spa. Press pump button 1 on the console (see USING THE CON- TROLS on page 13). Once the spa is running, press the GFCI “test” button. The spa should shut off. Press the “reset” button. The spa should resume normal operation. If the spa continues to run after the “test” button is pressed, the GFCI is damaged. Do not use the spa until the GFCI has been repaired or replaced by a qualified electrician.
To secure the spa cover, snap the latches on the spa cover into the buckles on the panels. To lock the buckles, insert the key and turn it clockwise 1/4 turn. To unlock the buckles, insert the key and turn it counterclockwise 1/4 turn.
Always keep the buckles locked when the spa is not in use. Keep the keys in a safe place, out of the reach of children.
Latch
Key
Buckle
12