Assembly
Place all parts of the hydrotherapy spa in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires your own phillips screwdriver
1.Before beginning assembly, make sure that you have read and understand the information above and on the previous two pages.
Remove the eight #10 x 2” Machine Screws (37) that secure the indicated Access Panel (25) to the spa. Carefully remove the Access Panel until the CD wire harness (not shown) is visible, and disconnect the CD wire. Set the Access Panel aside. Be careful not to damage the spa shell.
Insert the Pillow (38) into the lounge seat receptacle. Note: The Pillow can be rotated 180º and reattached in a high or low position.
2.Close the valve knob on the drain hose. Thread the cap onto the drain hose.
Locate the four gate valves inside the access open- ing (there are two gate valves per pump). Turn the gate valves counterclockwise to open them.
Make sure that the six collars are tightened (there are two collars per pump and two on the heater).
See step 1. Reconnect the CD wire harness to the CD Player and reattach the Access Panel (25) to the spa.
. |
1 |
38 |
37 |
25 |
37 |
2 |
Gate Valve
Drain
Hose
Collar
Cap Valve
Knob
9