ASSEMBLY
ATTACHING THE HANDLE
See Figure 4.
A barrier handle should be used for ensuring the best control and maximizing operator safety.
1.Place the handle base and the bracket on the shaft housing below the spacer.
2.Install the two handle base screws and nuts, but do not tighten completely.
3.Place the front handle grip onto the handle base and install the two screws. Tighten securely.
4.Adjust the position of the front handle for best balance and comfort.
5.Tighten the two handle base screws securely.
NOTE: Do not attempt to remove or modify the spacer. This spacer limits the upper position of the handle grip. See Figure 4.
SPACER
HANDLE BASE
SCREWS
HANDLE
BASE
HANDLE
BARRIER
BAR
BRACKET NUTS
STRAP HANGER
SPACER
FRONT HANDLE GRIP
SCREWS | Fig. 4 |
|