Ryobi Outdoor PBC3046E, RY70105 manual Attaching the Shoulder Strap, Muffler Guard

Page 9

ASSEMBLY

ATTACHING THE SHOULDER STRAP

See Figure 5.

1.Connect the latch on the shoulder strap to the strap hanger.

2.Adjust the strap to a comfortable position.

NOTE: To quickly release the product from the shoulder strap, sharply pull the quick release tab

SHOULDER

REAR HOUSING

TORX

WRENCH

SCREWS

MUFFLER

GUARD

QUICK

STRAP

RELEASE

TAB

LATCH

BENT END OF

MUFFLER GUARD

OPENING IN REAR

HOUSING

Fig. 6

STRAP HANGER

Fig. 5

MUFFLER GUARD

See Figure 6.

1.Remove muffler guard and two screws from the owner's kit.

2.Attach the muffler guard to the rear housing.

NOTE: Make sure the bent end of the muffler guard fits securely into the opening of the rear housing.

3.Using the torx wrench supplied, install the two screws and tighten securely.

NOTE: When converting from brushcutter to string trimmer, or string trimmer to brushcutter, make sure the correct guard/deflector is being used. See Figure 7.

GRASS DEFLECTOR FOR

STRING TRIMMER USE

BLADE GUARD FOR

BRUSHCUTTER USE

Fig. 7

Image 9

Contents Operators Manual Safety Table of ContentsSpecific Safety Rules for Brushcutter and Blade USE Specific Safety Rules for Trimmer USESymbol Name Explanation SymbolsVibration level racing Technical DataUnpacking FeaturesInstructions Packing List for Owners KITAttaching the Power Head to the Trimmer Attachment AssemblyRemoving the Attachment from the Power Head Attaching the Storage HangerAttaching the Handle Muffler Guard Attaching the Shoulder StrapBlade Guard Drive Connector Spool Retainer String HeadGrass Deflector Converting from String Trimmer to BrushcutterInstalling the String Head Installing the BladeConverting from Brushcutter to String Trimmer Removing the BladeOperation Fuel and RefuelingOperating the Trimmer Advancing the String Cutting TipsGrass Deflector Line Trimming CUT- OFF Blade Operating the Brushcutter TRI-ARC BladeCutting Technique Blade Starting and Stopping Ignition SwitchTo Start a Cold Engine To Start a Warm EngineSpool Replacement EZ Line TAP Advance System MaintenanceNEW Prewound Spool See Figures 18Blade Protector String ReplacementSpring Arrows on Spool Anchor Hole First StringReplacing and Cleaning AIR Filter Cleaning the Exhaust Port and MufflerSpark Arrestor See Figures 25Fuel CAP Spark PlugStorage 1 Month or Longer Troubleshooting Idle Speed Screw Needle Safety Directive WarrantyGuarantee Statement Rtsa / Rtuk / RTG EC Declaration of ConformityPage 983000-202