Ryobi Outdoor PLT3043E, RY70103 manual See Figure, Idle Speed Screw Needle

Page 16

TROUBLESHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.

 

PROBLEM

POSSIBLE CAUSE

SOLUTION

 

 

 

 

 

 

Grass wraps round drive

1.

Cutting tall grass at

1.

Cut tall grass from the top down.

shaft housing and

 

ground level.

 

 

 

string head:

2.

Operating trimmer at

2.

Operate trimmer at full throttle.

 

 

 

part throttle.

 

 

 

 

 

 

 

 

Spool retainer hard to

Screw threads dirty or damaged.

Clean threads and lubricate with grease - if no

turn:

 

 

improvement, replace spool retainer.

 

 

 

 

 

 

 

Oil drips from silencer:

1.

Operating trimmer at

1.

Operate trimmer at full throttle.

 

 

 

part throttle.

 

 

 

 

 

2.

Check oil/fuel mixture.

2.

Use fresh fuel and the correct 2-cycle oil mix.

 

 

3.

Air filter dirty.

3.

Clean per instruction in Maintenance Section.

 

 

4.

Carburettor requires

4.

Turn “H” needle clockwise 1/16 - 1/8 turn.

 

 

 

adjustment.

 

See Figure 18.

 

 

 

 

 

 

 

NOTE: The carburettor adjustment needle(s) are equipped with plastic cap(s) which prevent anticlockwise rotation from the original factory adjustment. If your unit exhibits specific performance problem(s) where the Trouble Shooting Section recommends an anticlockwise needle adjustment and no adjustments have been made since original purchase,

the unit should be taken to a factory-authorised service dealer for repair. In most cases, the needed adjustment is a simple task for the factory-trained service representative.

IDLE SPEED

SCREW

“L” LO

NEEDLE

“H” HIGH NEEDLE

Fig. 18

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents OPERATOR’S Manual Table of Contents SafetySpecific Safety Rules for Trimmer USE Symbols Symbol Name ExplanationTechnical Data Features UnpackingInstructions Packing List for OWNER’S KITAssembly Assembly InstructionsSee Figure Handle Base Screws Bracket Nuts Spacer Handle GripSilencer Guard Assembly Fuel and Refuelling OperationOperating the Trimmer Advancing String Using the EZ Line TAP Advance System Advancing the StringCutting Tips Grass Deflector Line Trimming CUT-OFF BladeStarting and Stopping Maintenance Spool Replacement EZ Line TAP Advance SystemNEW PRE-WOUND Spool See Figures 10 Cleaning the Exhaust Port and Silencer String Replacement Spark Arrester Arrows on Spool Anchor Hole First StringReplacing and Cleaning AIR Filter Fuel CAPSparking Plug Storage 1 Month or LongerTroubleshooting Idle speed. See FigureIdle Speed Screw Needle Warranty Safety DirectiveGuarantee Statement Rtsa / Rtuk / RTG Sound Pressure Sound Power Vibration Model Model noRyobi Technologies GmbH
Top Page Image Contents