Ryobi Outdoor RY52002 manual Position for Starting, Starting and Stopping, See Figures 14

Page 14

OPERATION

POSITION FOR STARTING

See Figure 13.

Lay the pruner on the ground and ensure that no objects or obstructions are in the immediate vicinity. Make sure nothing can come in contact with the bar and chain.

Fig. 13

STARTING AND STOPPING

See Figures 14 - 16.

TO START A COLD ENGINE:

DO NOT squeeze the throttle trigger until the engine starts and runs.

n Lay the trimmer on a flat, bare surface. n PRIME - Press the primer bulb 7 times. n SET the start lever to the START position. n PULL the rope until the engine starts.

n Allow the engine to run for 15 seconds. n Squeeze trigger lock and throttle trigger.

NOTE: Squeezing the throttle trigger releases the start lever to the RUN position.

TO START A WARM ENGINE:

PULL the rope until the engine starts.

TO STOP THE ENGINE:

Press and hold the switch in the stop “ ” position until the engine stops.

ENGINE

SWITCH

TRIGGER

LOCK

THROTTLE

 

TRIGGER

Fig. 14

 

STARTER

GRIP

ENGINE

SWITCH

PRIMER BULB

TRIGGER

LOCK

THROTTLE TRIGGER

Fig. 15

START LEVER

START

POSITION

START LEVER

RUN

POSITION

Fig. 16

14

Image 14
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules for Trimmer USE Specific Safety RulesSpecific Safety Rules for Pruner USE RefuelingSymbols Symbol Name DESIGNATION/EXPLANATIONService Throttle Trigger Product SpecificationsStarter Grip Chain Oiler Tank CAP Engine Switch Coupler KnobFeatures AssemblyAttaching the J Barrier Handle Installing the Shoulder StrapConnecting the Power Head to Pruner AttachmentPremium Exact MIX Chain OilerFueling and Refueling See Figures 6 OperationPreparation for Pruner Cutting See Figures 8 Limbing and PruningOperating the Trimmer MaximumCutting Tips To Advance the Cutting LineTo Advance the Cutting Line Manually Grass Deflector Line Trimming CUT-OFF BladeSee Figures 14 Position for StartingStarting and Stopping Chain Tension MaintenanceGeneral Maintenance See Figures 17Chain BAR BAR NUT Replacing the BARSee Figures 19 BAR NUT Chain Tensioning ScrewChain Oiler Tank Replace CAP Remove Idle Speed AdjustmentIdle Speed Screw See Figures 28 Chain MaintenanceHOW to Sharpen the Cutters See Figures 32 Spool ReplacementNEW Prewound Spool Spool Retainer Spring Slots Eyelets String Head ShaftArrows on Spool Anchor Hole String ReplacementSee Figures 34 First String SlotSpark Arrestor Cleaning the Exhaust Port and MufflerReplacing and Cleaning AIR Filter Fuel CAPTroubleshooting Problem Cause RemedyWarranty Limited Warranty StatementMaintenance Requirements MANUFACTURER’S Warranty CoverageOWNER’S Warranty Responsibilities CoverageThis Product WAS Manufactured with a Catalyst Muffler Service Model NO. and Serial no California Proposition